Driving information
– If the night vision assist thermal image is re-
placed by another display (such as the on-board
computer), the red or warning symbol
will appear if there is a pedestrian, cyclist, or
wild animal warning.
Integrated Toll Module
Description
Applies to: vehicles with Integrated Toll Module
Depending on the region, you can pay toll fees in
certain countries using the Integrated Toll Mod-
ule (ITM). It replaces a separate transponder for
detecting toll fees. The system electronics are in-
tegrated in the rearview mirror housing.
The symbol will appear when pedestrian, cy-
clist, and wild animal detection is not available.
Marking light*
To direct attention to the pedestrian or the cy-
clist, the pedestrian or cyclist can be illuminated
by the headlights when there is a pedestrian
warning.
To use the ITM in toll zones, you must register
and activate it.
Registration
►
Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Integrated Toll
Module.
Note the Integrated Toll Module ID.
To register the ITM, go to the displayed web ad-
This occurs at speeds above approximately
35 mph (60 km/h) if you are outside of illuminat-
ed areas and no detected vehicles are shown. The
marking light is not used for wild animals. The
high beam assistant* controls the marking
light*ðpage 55.
►
►
dress and follow the instructions.
Activation
Adjusting the contrast
Applies to: vehicles with night vision assist
►
To activate the ITM, press in the MMI.
Entering the number of passengers
Requirement: the night vision assist must be
turned on and the tab must be displayed.
A lower toll fee may be charged depending on the
number of passengers and the region. You must
either enter the number of passengers or deacti-
vate the ITM based on the laws applicable in the
area where you are driving.
►
Applies to MMI: Select on the home screen: VE-
HICLE > Driver assistance > () > Night vision
assist.
►
To set the desired contrast, move the slider.
►
To enter the number of passengers, select the
appropriate button in the MMI.
To deactivate the ITM, press in the MMI.
Messages
Applies to: vehicles with night vision assist
►
The following messages may appear, depending
on the vehicle equipment:
Tips
– The driver is responsible for specifying the
correct number of passengers and activat-
ing or deactivating the ITM.
Night vision assist: currently unavailable.
See owner's manual
– Malfunctions can occur when detecting tolls
if both the ITM and transponder are activat-
ed. Deactivate the system not being used or
remove it as necessary.
The system is not functioning correctly at the
time, so it has been turned off. If the malfunction
persists, drive immediately to an authorized Audi
dealer or authorized Audi Service Facility to have
the malfunction corrected.
– If the rearview mirror is replaced, you must
register the new ITM and remove the old
ITM from the account.
– The system complies with United States FCC
regulations and ISED regulations
ðpage 330.
142
English 
