Opening and closing
CONTROLS
Initialization begins within 15 seconds.
Closing from the lifted position without
the anti-trap mechanism
▷
▷
▷
If the glass sunroof is closed, it opens then
closes again.
In case of danger from the outside or if icing
might prevent normal closing, proceed as fol-
lows:
If the glass sunroof is open, it first closes,
then opens and closes again.
The sun protection is initialized in the
closed position.
Initialization is complete once the glass sun-
roof and the sun protection have opened then
closed again.
1. Close all doors.
2. Switch on drive-ready state or stop a mov-
ing vehicle.
Fixed glass roof
3. Push the switch forward past the resistance
point and hold.
General
The glass sunroof sun protection can be
opened or closed.
Initializing after a power interruption
The sun protection opens from rear to front.
General information
After a power interruption during the opening
or closing process, the glass sunroof can only
be operated to a limited extent. Initializing the
system can help in this case.
With the vehicle key
Opening the sun protection
Press and hold the button on the vehi-
cle key after unlocking.
The system can be initialized under the follow-
ing conditions:
▷
The vehicle is parked in a horizontal posi-
tion.
The glass sunroof sun protection is opened
as long as the button on the vehicle key is
pressed.
▷
The vehicle will not be moved until the initi-
alization is completed.
Closing the sun protection
▷
▷
The drive-ready state is established.
With Comfort Access: press and hold
the button on the vehicle key in close
range of the vehicle after locking.
The outside temperature is above
41 ℉/5 ℃.
During initialization, the glass sunroof closes
without the anti-trap mechanism.
The glass sunroof sun protection is closed
as long as the button on the vehicle key is
pressed.
Make sure that the closing path is clear.
Initializing the system
Depending on the vehicle equipment, exterior
mirrors are folded in unless they were folded
in while locking. The exterior mirrors are not
folded in when the hazard warning flashers are
switched on.
Press the switch up and hold
it until the initialization is com-
plete:
105
Online Edition for Part no. 01405B37D97 - II/24