2014-2019 BMW M3 4 Door Mobility -> Care User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Mobility -> Care for Your BMW M3 4 Door Fifth Generation (2014-2019)

Mobility  
Care  
Care  
Minimum distance from glass sunroof:  
31.5 in/80 cm.  
Vehicle features and options  
This chapter describes all standard, country-  
specific and optional features offered with the  
series. It also describes features that are not  
necessarily available in your vehicle, e. g., due  
to the selected options or country versions.  
This also applies to safety-related functions  
and systems. When using these functions and  
systems, the applicable laws and regulations  
must be observed.  
Automatic vehicle washes  
Safety information  
NOTE  
Improper use of automatic vehicle  
washes can cause damage to the vehicle.  
There is a risk of damage to property. Follow  
the following instructions:  
Give preference to cloth vehicle washes or  
those that use soft brushes in order to  
avoid paint damage.  
Vehicle washes  
General information  
Avoid vehicle washes with guide rails  
higher than 4 in/10 cm to avoid damage to  
the chassis.  
Regularly remove foreign objects such as  
leaves in the area below the windshield when  
the hood is raised.  
Observe the tire width of the guide rail to  
avoid damage to tires and rims.  
Wash your vehicle frequently, particularly in  
winter. Intense soiling and road salt can dam‐  
age the vehicle.  
Fold in exterior mirrors to avoid damage to  
the exterior mirrors.  
Deactivate the wiper and, if necessary, rain  
sensor to avoid damage to the wiper sys‐  
tem.◀  
Steam blaster and high-pressure  
washer  
Safety information  
Before driving into a vehicle wash  
In order to ensure that the vehicle can roll in a  
vehicle wash, take the following steps:  
NOTE  
When cleaning with high-pressure wash‐  
ers, components can be damaged due to the  
pressure or temperatures being too high.  
There is a risk of property damage. Maintain  
sufficient distance and do not spray too long  
continuously. Follow the operating instructions  
for the high-pressure washer.◀  
Manual transmission:  
1. Drive into the vehicle wash.  
2. Shift to neutral.  
3. Switch the engine off.  
M double-clutch transmission:  
Distances and temperature  
1. Drive into the vehicle wash.  
2. Engage selector lever position N.  
3. Switch the engine off.  
Maximum temperature: 140 ℉/60 ℃.  
Minimum distance from sensors, cameras,  
seals: 12 inches/30 cm.  
216  
 
Care  
Mobility  
In this way, the ignition remains switched  
on, and a Check-Control message is dis‐  
played.  
Thaw ice with de-icing spray; do not use an ice  
scraper.  
After washing the vehicle  
NOTE  
After washing the vehicle, apply the brakes  
briefly to dry them; otherwise, braking action  
can be reduced. The heat generated during  
braking dries brake discs and brake pads and  
protects them against corrosion.  
Selector lever position P is automati‐  
cally engaged when the ignition is  
switched off. There is a risk of property  
damage. Do not switch drive-ready state  
off in vehicle washes.◀  
Completely remove all residues on the win‐  
dows, to minimize loss of visibility due to  
smearing and to reduce wiper noises and  
wiper blade wear.  
Some vehicle washes do not permit persons in  
the vehicle. The vehicle cannot be locked from  
the outside when in selector lever position N. A  
signal sounds when an attempt is made to lock  
the vehicle.  
Vehicle care  
Driving out of a vehicle wash  
To start the engine with manual transmission:  
Vehicle care products  
1. Ensure that the vehicle key is in the car.  
2. Press on the clutch pedal.  
General information  
BMW recommends using vehicle care and  
cleaning products from BMW. Suitable care  
products are available from a dealer’s service  
center or another qualified service center or re‐  
pair shop.  
3. Press the Start/Stop button.  
To start the engine with a M double clutch  
transmission:  
1. Ensure that the vehicle key is in the car.  
2. Depress the brake pedal.  
Safety information  
3. Press the Start/Stop button.  
WARNING  
Pressing the Start/Stop button without step‐  
ping on the brake turns the ignition off.  
Cleansers can contain substances that  
are dangerous and harmful to your health.  
There is a risk of injury. When cleaning the in‐  
terior, open the doors or windows. Only use  
products intended for cleaning vehicles. Fol‐  
low the instructions on the container.◀  
Transmission position  
Transmission position P is engaged automati‐  
cally:  
When the ignition is switched off.  
After approx. 15 minutes.  
Vehicle paint  
General information  
Headlights  
Regular care contributes to driving safety and  
value retention. Environmental influences in  
areas with elevated air pollution or natural con‐  
taminants, such as tree resin or pollen can af‐  
fect the vehicle's paintwork. Tailor the fre‐  
Do not rub the headlights dry and do not use  
abrasive or acidic cleaning agents.  
Soak areas that have been dirtied, for instance  
from insects, with shampoo and wash off with  
water.  
217  
 
Mobility  
Care  
quency and extent of your vehicle care to  
these influences.  
Safety information  
NOTE  
Aggressive substances such as spilled fuel, oil,  
grease or bird droppings, must be removed im‐  
mediately to prevent the finish from being al‐  
tered or discolored.  
Open Velcro® fasteners on articles of  
clothing can damage the seat covers. There is  
a risk of property damage. Ensure that any Vel‐  
cro® fasteners are closed.◀  
Matte finish  
Only use cleaning and care products suitable  
for vehicles with matte finish.  
Caring for special components  
Light-alloy wheels  
When cleaning the vehicle, use only neutral  
wheel cleaners having a pH value from 5 to 9.  
Do not use abrasive cleaning agents or steam  
jets above 140 ℉/60 ℃. Follow the manufac‐  
turer's instructions.  
Leather care  
Remove dust from the leather regularly, using  
a cloth or vacuum cleaner.  
Otherwise, particles of dust and road grime  
chafe in pores and folds, and lead to increased  
wear and premature degradation of the leather  
surface.  
Aggressive, acidic or alkaline cleaning agents  
can destroy the protective layer of adjacent  
components, such as the brake disk.  
To guard against discoloration, such as from  
clothing, clean leather and provide leather care  
roughly every two months.  
After cleaning, apply the brakes briefly to dry  
them. The heat generated during braking dries  
brake discs and brake pads and protects them  
against corrosion.  
Clean light-colored leather more frequently be‐  
cause soiling on such surfaces is substantially  
more visible.  
Chrome surfaces  
Use leather care products; otherwise, dirt and  
grease will gradually break down the protective  
layer of the leather surface.  
Carefully clean components such as the radia‐  
tor grille or door handles with an ample supply  
of water, possibly with shampoo added, partic‐  
ularly when they have been exposed to road  
salt.  
Upholstery material care  
General information  
Rubber components  
Vacuum the upholstery regularly with a vac‐  
uum cleaner.  
Environmental influences can cause surface  
soiling of rubber parts and a loss of gloss. Use  
only water and suitable cleaning agents for  
cleaning.  
If upholstery is very dirty, for instance with bev‐  
erage stains, use a soft sponge or microfiber  
cloth with a suitable interior cleaner.  
Treat especially worn rubber parts with rubber  
care agents at regular intervals. When cleaning  
rubber seals, do not use any silicon-containing  
vehicle care products in order to avoid damage  
or noises.  
Clean the upholstery down to the seams using  
large sweeping motions. Avoid rubbing the  
material vigorously.  
218  
 
Care  
Mobility  
Fine wood parts  
Carpets and floor mats  
Clean fine wood facing and fine wood compo‐  
nents only with a moist rag. Then dry with a  
soft cloth.  
WARNING  
Objects in the driver's floor area can limit  
the pedal distance or block a depressed pedal.  
There is a risk of an accident. Stow objects in  
the vehicle such that they are secured and  
cannot enter into the driver's floor area. Use  
floor mats that are suitable for the vehicle and  
can be safely attached to the floor. Do not use  
loose floor mats and do not layer several floor  
mats. Make sure that there is sufficient clear‐  
ance for the pedals. Ensure that the floor mats  
are securely fastened again after they were re‐  
moved, e.g., for cleaning.◀  
Plastic components  
NOTE  
Cleansers that contain alcohol or sol‐  
vents, such as lacquer thinners, heavy-duty  
grease removers, fuel, or such, can damage  
plastic parts. There is a risk of property dam‐  
age. Clean with a microfiber cloth. Dampen  
cloth lightly with water.◀  
Plastic components are e.g.:  
Floor mats can be removed from the vehicle's  
interior for cleaning.  
Imitation leather surfaces.  
Roofliner.  
If the floor carpets are very dirty, clean with a  
microfiber cloth and water or a textile cleaner.  
To prevent matting of the carpet, rub back and  
forth in the direction of travel only.  
Lamp lenses.  
Instrument cluster cover.  
Matt black spray-coated components.  
Painted parts in the interior.  
Sensor/camera lenses  
Clean with a microfiber cloth.  
Dampen cloth lightly with water.  
Do not soak the roofliner.  
To clean sensors and camera lenses, use a  
cloth moistened with a small amount of glass  
detergent.  
Displays/Screens/protective glass of  
the Head-up Display  
Safety belts  
WARNING  
NOTE  
Chemical cleansers can destroy the  
safety belt webbing. Missing protective effect  
of the safety belts. There is a risk of injuries or  
danger to life. Use only a mild soapy solution  
for cleaning the safety belts.◀  
Chemical cleansers, moisture or fluids of  
any kind can damage the surface of displays  
and screens. There is a risk of property dam‐  
age. Clean with a clean, antistatic microfiber  
cloth.◀  
Dirty belt straps impede the reeling action and  
thus have a negative impact on safety.  
NOTE  
Use only a mild soapy solution, with the safety  
belts clipped into their buckles.  
The surface of displays can be damaged  
with improper cleaning. There is a risk of prop‐  
erty damage. Avoid pressure that is too high  
and do not use any scratching materials.◀  
Do not allow the switchs to retract the safety  
belts until they are dry.  
Clean with a clean, antistatic microfiber cloth.  
219  
 
Mobility  
Care  
Clean the protective glass of the Head-up Dis‐  
play using a microfiber cloth and commercially  
available dish-washing soap.  
Long-term vehicle storage  
When the vehicle is shut down for longer than  
three months, special measures must be  
taken. Further information is available from a  
dealer’s service center or another qualified  
service center or repair shop.  
220  
 
Care  
Mobility  
221  
 

Related Topics

Popular Owner Manuals