Get Operation, care and maintenance -> Airbags (Notice), Vehicle storage Guide for BMW Z8 Roadster First Generation (2000-2003)

Airbags

123n

Do not modifiy or tamper with either the

wiring or the individual components in

the airbag system. These include the

padded steering wheel hub, the instru-

ment panel, and the side trim panels of

the doors. Never apply adhesive mate-

rials to these components or cover or

modify them in any way. Do not remove

or dismantle the steering wheel your-

self.

To ensure compliance with applicable

safety regulations, have a BMW center

dispose of airbag generators.

1 Front airbags on the driver and

passenger side

Unprofessional attempts to service the

system could lead to failure in an emer-

gency or undesired airbag activation,

either of which could result in personal

injury.<

2 Side airbags on the driver and front

passenger side

Important safety notices

Do not attempt to remove the gas

generators of the airbag restraint

system from the vehicle. Testing and

servicing are to be performed only by

trained technicians.

In the event of a malfunction, deactiva-

tion, or triggered actuation (as a

response to an accident) of the airbag

restraint system, consult your BMW

center for repairs or service operations.

¹²⁴ⁿVehicle storage

If the vehicle is to be stored for

4. Check the fluid level of the wind-

shield washer fluid reservoir; top off

if necessary

During storage

more than three months, ensure

that the following service operations

are carried out first.<

Recharge a battery that has been taken

out of the vehicle every six months. If it

is not recharged, it will not be service-

able. Every time the battery is

5. Fill the fuel tank completely to

prevent the formation of condensa-

tion

Preparations for storage

discharged, especially over extended

periods, its service life is reduced.

6. Increase the tire inflation pressure to

51 psi (350 kPa).

Have your BMW center perform the

following procedures:

Removing the vehicle from

storage

1. Clean and apply a rust proofing

agent or other treatment to the

Before parking the vehicle

1. Dry the parking brake and footbrake

by brake applications to prevent the

brake discs and drums from

corroding

engine, engine compartment, under-

carriage, axles and major compo-

nents in accordance with approved

repair procedures. Wash the vehicle,

clean the interior and treat painted

and chromed parts. Clean the

Recharge the battery if the "Magic Eye"

turns black, refer to page 138.

Then have Inspection I performed by

your BMW center, including a brake

fluid replacement, if necessary. Refer to

the Service and Warranty Information

Booklet (US models) or the Warranty

and Service Guide Booklet (Canadian

models).

2. Park the vehicle in a covered, dry,

and well-ventilated area. Place the

transmission in first gear or, if neces-

sary, chock the wheels to prevent the

vehicle from rolling. Do not engage

the parking brake

weather-stripping around the hood,

luggage compartment and doors

2. Change engine oil and oil filter at

operating temperature. As an addi-

tional corrosion protection measure,

an anticorrosive agent can be added

to the engine in accordance with the

manufacturer's instructions

3. Remove the battery, charge it

completely and store it in a cool (but

frost-free) room

4. Remove the hardtop and store it

separately, refer to page 96

5. Close the convertible top.

3. Check the coolant level and concen-

tration and top off if necessary

Operation, care and maintenance -> Airbags (Notice), Vehicle storage for Your BMW Z8 Roadster First Generation (2000-2003)

Related Topics

Operation, care and maintenance

Popular Owner Manuals

Latest Owner Manuals