Operation, care and maintenance -> Wind deflector, Hardtop for Your BMW Z8 Roadster First Generation (2000-2003)

Car radio reception  
Wind deflector  
95n  
The reception and sound quality  
obtained from mobile radios vary  
according to a variety of factors,  
including the broadcast range of the  
transmitter and the directional orienta-  
tion of the antenna. Interference factors  
such as high-tension power lines,  
structural or natural obstructions can all  
lead to unavoidable reception interfer-  
ence, regardless of how well the vehicle  
sound system is operating. Climatic  
factors such as intense solar radiation,  
fog, rain and snow can also interfere  
with reception.  
Mounting  
2. Guide the four fasteners to their  
respective slots, attach them at an  
angle, and press them into place  
using the strap hanging in front of  
them. Shove the four straps under  
the inner side of the convertible top  
3. Shove both the center elements all  
Attach the wind deflector while the  
convertible top is open and its cover is  
not mounted.  
Radio interference can also be caused  
by either cellular phones not recom-  
mended by BMW or by portable  
phones. This phenomenon assumes the  
form of a low-pitched hum emanating  
from the speaker system.  
1. Push the brackets for the wind  
deflector, with the zippers fastened  
and facing to the front, onto both roll-  
over protection bars as far as to the  
upper edge of the chrome collars  
(arrow)  
the way to the vehicle's outside edge  
(arrows), so that the cover can then  
easily be mounted  
Please refer to the Owner's Manual that  
you received for detailed information on  
settings and operation of your radio.  
4. Fit the cover if you wish to drive with  
the convertible top open (refer to  
page 42).  
You will find additional details  
concerning radio reception in the  
chapter "Advanced technology" on  
page 150.  
96nWind deflector  
Hardtop  
Removal  
Pull the four straps to release the  
retainers, then reverse the installation  
sequence to remove the wind deflector.  
Fold the wind deflector and place it in  
its protective slipcase prior to storing it  
in the luggage compartment.  
While driving  
Removal  
You can always drive with the wind Your BMW Z8 roadster is equipped  
deflector installed. Whenever the with a hardtop as standard equipment.  
convertible top is closed, flip the center Two individuals are required for its  
section of the wind deflector down to  
get a better view to the rear.  
removal. When removing the top,  
always proceed with utmost caution to  
avoid damage to the vehicle's paint and  
bodywork as well as to the hardtop  
itself.  
1. With the two stud fasteners closed,  
first unfasten the zippers entirely.  
2. Release the two stud fasteners and  
lay down the center section either to 1. Set up the hardtop cart as described  
the rear or the front, as shown in the  
illustration.  
in the accompanying assembly  
instructions  
2. Lower the side windows.  
3. Press to release the side trim (arrow)  
When reattaching, first fasten the two  
stud fasteners, then zip the zippers up.  
Every time you press on it, you  
either lock or unlock the side trim  
panel.<  
Hardtop  
97n  
4. Remove both the left and right side  
trim panels  
5. Remove the tool used for locking the  
6. Remove the two oval cover panels  
from the front of the hardtop frame,  
using a screwdriver, if necessary  
9. Place the hardtop on the hardtop  
cart as described in the enclosed  
assembly instructions.  
hardtop, located next to the hardtop 7. Position the tool for locking the  
catch on the left side, position the  
tool and turn it forward until you hear  
an audible click. Do this both on the  
left and right side of the hardtop to  
release both catches  
hardtop, and turn it outward until you  
hear an audible click. Do this both on  
the left and right side of the hardtop  
frame to release both catches  
8. The hardtop's detent mechanism is  
now completely disengaged. With  
the aid of an assistant, lift the  
hardtop up and over the rear of the  
vehicle  
To avoid possible damage, take  
care not to jam the electrical wires  
on the left and right sides.<  
Do not set the hardtop down  
upright, as damage could result.<  
98nHardtop  
Two individuals are required for  
removal and installation. When  
removing and installing the top, always  
proceed with utmost caution to avoid  
damage to the vehicle's paint and  
bodywork or to the hardtop itself.  
The hardtop headining fabric must  
not contact the hardtop cart.  
Otherwise it jams and can lead to  
damage.<  
Installing  
10. Press the left and right protective  
covers onto the hardtop brackets.  
Goes the same way as for taking the  
hardtop off, just do it in reverse order.  
Attach the protective cloth insert to the  
roof brace (arrow) before placing the  
convertible top on the hardtop cart.  
Whenever the hardtop is in constant  
use, the fabric convertible top does not  
need to be dismantled, even in winter.  
Before storing the fabric convertible top  
in the convertible top compartment, it  
has to be completely dry to keep any  
water or mildew stains from forming.