Steering wheel controls
Exceeding the programmed
speed
Switching the function off
Operating fault
-
Place the dial in position 0 or switch
off the ignition to switch the system
off.
The programmed speed is cleared
then replaced by three dashes.
Contact a CITROËN dealer to have the
system checked.
Pressing the accelerator pedal in order
to exceed the programmed speed
will have no effect unless you press
the pedal firmly beyond the point of
resistance.
The last programmed speed remains in
the memory.
The limiter is deactivated temporarily
and the programmed speed flashes.
To return to the limiter function, reduce
your speed to below the programmed
speed.
Good practice
In any event, the speed limiter cannot
replace the need to observe speed
limits, nor can it replace the need for
vigilance and responsibility on the part
of the driver.
Always pay attention to the profile of the
road and sharp acceleration and stay in
complete control of your vehicle.
Flashing of the speed
The speed flashes:
-
To avoid any jamming under the pedals:
-
following forcing of the accelerator
point of resistance,
ensure that the mat and its fixings
on the floor are positioned correctly,
-
when the limiter cannot prevent an
increase in the vehicle speed due
to the profile of the road or on a
steep descent,
-
never place one mat on top of
another.
-
in the event of sharp acceleration.
English 
