Get Access -> Alarm Guide for Citroen Berlingo SUV Third Generation (2018-2025)

Access

This roof ﬂap at the rear is compatible only with

side-hinged doors.

Support bar

The vehicle is equipped with a support bar for

transporting long loads, after opening the rear

roof ﬂap.

Alarm

► Fold back the support bar by lifting the lever.

► Guide it to the door pillar.

► Support the long loads to be transported, lift

them and reposition the support bar with one

hand.

► Ensure that it is secured correctly by

pressing the handle downwards past the point of

resistance and lash the load securely.

The side supports can be used as hooking

points.

System which protects and provides a deterrent

against theft and break-ins.

To open the rear roof ﬂap:

– Lift the black paddle of the toggle.

– Relax the toggle by pressing on the rear roof

ﬂap (downwards) then release the hook.

– Lift the rear roof ﬂap.

– Move past the point of resistance to lock the

rear roof ﬂap with the support props.

Self-protection function

The system checks for any malfunction

in its components.

The alarm is triggered if the battery, button or

siren wiring is disconnected or damaged.

For all work on the alarm system, contact a

CITROËN dealer or a qualiﬁed workshop.

The rear bumper has been reinforced to

serve as a step when entering the

vehicle.

Never drive without the props in place.

Never fasten a load to the roof ﬂap.

To close the rear roof ﬂap:

Exterior perimeter

– Check that the support bar is properly

secured.

– Lower the rear roof ﬂap.

Never drive without the support bar in

place.

The rear doors will only lock when the support

bar is installed.

When the roof ﬂap is open, take care when

driving where height is restricted.

Never rest loads directly on the rear doors.

Comply with the usual indications for warning

other drivers.

The system checks whether the vehicle is

opened.

– While pressing on the rear roof ﬂap

(downwards), take the two spring rings and then

place the hook in its housing.

– Lower the black paddle to lock the rear roof

ﬂap.

Locking the rear roof ﬂap holds it ﬁrmly against

the seal, ensuring watertight sealing with no

noise.

The alarm is triggered if anyone tries to open

one of the doors or the bonnet.

Volumetric

(without partition)

Only use the roof ﬂap on short trips.

Access

When the vehicle is parked, the alarm

will not be triggered if the vehicle is

knocked.

► Unlock the vehicle with the "Keyless Entry

and Start" system.

The monitoring system is deactivated: the

indicator lamp in the button goes oﬀ and the

direction indicators ﬂash for about 2 seconds.

The system checks for any variation in volume in

the passenger compartment.

The alarm is triggered if anyone breaks a

window, enters the passenger compartment or

moves inside the vehicle.

Locking the vehicle with full

alarm system

If the vehicle automatically locks itself

again (as happens if a door or the boot is

not opened within 30 seconds of unlocking),

the monitoring system is also reactivated

automatically.

Activation

► Switch oﬀ the ignition and exit the vehicle.

► Lock the vehicle using the remote control or

with the "Keyless Entry and Start" system.

The monitoring system is active: the red indicator

lamp in the button ﬂashes every second and

the direction indicators come on for about 2

seconds.

(with partition)

The system only checks for a variation in volume

inside the cab.

The alarm is triggered if anyone breaks a

window or enters the vehicle’s cab.

It will not be triggered if someone enters the

loading area.

Locking the vehicle

with exterior perimeter

monitoring only

Deactivate the interior volumetric and anti-tilt

monitoring to avoid the unwanted triggering of

the alarm, in certain cases such as:

– Slightly open window or sunroof.

– Washing the vehicle.

Following an instruction to lock the

vehicle, the exterior perimeter monitoring

is activated after 5 seconds and the interior

volumetric and anti-tilt monitoring after 45

seconds.

If your vehicle is ﬁtted with an Additional

heating/ventilation system, interior

volumetric monitoring is not compatible with it.

For more information on the Additional

heating/ventilation system, refer to the

corresponding section.

– Changing a wheel.

– Towing the vehicle.

– Transport on a ship or ferry.

If a door, the tailgate or the bonnet is not

closed properly, the vehicle is not locked

but the exterior perimeter monitoring will be

activated after 45 seconds at the same time

as the interior volumetric and anti-tilt

monitoring.

Deactivating the interior volumetric

and anti-tilt monitoring

► Switch oﬀ the ignition and within 10 seconds

press the alarm button until its red indicator lamp

is on ﬁxed.

Anti-tilt

The system checks for any change in the attitude

of the vehicle.

The alarm is triggered if the vehicle is lifted or

moved.

Deactivation

► Press the remote control unlocking button.

► Get out of the vehicle.

Access

remote control or unlock the vehicle using the

► Immediately lock the vehicle using the remote

control or the "Keyless Entry and Start" system.

Only the exterior perimeter monitoring is

activated; the button's red indicator lamp ﬂashes

once every second.

informs you that the alarm was triggered during

your absence. When the ignition is switched on,

this ﬂashing stops immediately.

"Keyless Entry and Start" system.

Electric windows

Failure of the remote control

To deactivate the monitoring functions:

► Unlock the vehicle using the key in the front

left-hand door lock.

► Open the door; the alarm is triggered.

► Switch on the ignition; this stops the alarm.

The indicator lamp in the button goes oﬀ.

To be taken into account, the deactivation

must be carried out every time the

ignition is switched oﬀ.

Type 1

Reactivating the interior volumetric

and anti-tilt monitoring

Locking the vehicle without

activating the alarm

► Lock or deadlock the vehicle using the key

(built-in the remote control) in the driver's door

lock.

► Deactivate the exterior perimeter monitoring

by unlocking the vehicle using the remote control

or the "Keyless Entry and Start" system.

The indicator lamp in the button goes oﬀ.

► Reactivate all monitoring by locking the

vehicle using the remote control or the "Keyless

Entry and Start" system.

1. Left-hand front.

2. Right-hand front.

Type 2

Malfunction

When the ignition is switched on, the ﬁxed

lighting of the red indicator lamp in the button

indicates a system malfunction.

Have it checked by a CITROËN dealer or a

qualiﬁed workshop.

The red indicator lamp in the button once again

ﬂashes every second.

Triggering of the alarm

This is indicated by sounding of the siren

and ﬂashing of the direction indicators for 30

seconds.

Depending on the country of sale, certain

monitoring functions remain active until the alarm

has been triggered eleven times consecutively.

When the vehicle is unlocked using the remote

control or the "Keyless Entry and Start" system,

rapid ﬂashing of the indicator lamp in the button

Automatic activation

(Depending on version)

The system is activated automatically 2 minutes

after the last door or the boot is closed.

► To avoid triggering the alarm on entering the

vehicle, ﬁrst press the unlocking button on the

Access -> Alarm for Your Citroen Berlingo SUV Third Generation (2018-2025)

Related Topics

Access

Popular Owner Manuals

Latest Owner Manuals