Advertisement

Advertisement

Instruments -> Distance recorders for Your Citroen Berlingo SUV Third Generation (2018-2025)

Instruments  
Have your vehicle serviced very soon.  
If you have to disconnect the battery  
following this operation, lock the vehicle  
and wait at least 5 minutes for the reset to be  
registered.  
1
Service spanner flashing  
Flashing then fixed, when the  
ignition is switched on.  
(With BlueHDi Diesel engines, associated with  
the Service warning lamp.)  
Reminder of the servicing information  
The servicing interval has been exceeded.  
Have your vehicle serviced as soon as possible.  
You can access the servicing information at any  
time.  
With LCD symbols and LCD text or matrix  
instrument panel  
► Press the trip distance recorder reset button.  
With digital instrument panel  
You can view the servicing information by  
pressing the "Check" button in the  
Driving/Vehicle touch screen menu.  
The servicing information is displayed for a few  
seconds, then disappears.  
Resetting the service indicator  
The service indicator must be reset after each  
service.  
► Switch the ignition off.  
With LCD symbols and LCD text or matrix  
instrument panel  
With the vehicle stationary, use the left-hand  
thumbwheel on the steering wheel or the "SET"  
button on the instrument panel to move through  
the menus to configure certain vehicle settings.  
Thumbwheel operation:  
– Press: open the Main menu; confirm the  
selection.  
– Rotate (other than in a menu): scroll through  
the list of available active functions.  
– Rotate (in a menu): move up or down in the  
menu.  
Instrument panel display screen  
With LCD symbols and LCD text or matrix  
instrument panel  
With digital instrument panel  
You can configure some of the vehicle's  
settings by pressing the "Check" button in  
the Driving/Vehicle touch screen menu.  
► Press and hold this button.  
► Switch on the ignition; the distance recorder  
display begins a countdown.  
► Release the button when =0 is displayed; the  
spanner disappears.  
With digital instrument panel  
The service indicator is reset using the  
"Check" button in the Driving/Vehicle  
touch screen menu.  
Distance recorders  
The total and trip distances are displayed for  
thirty seconds when the ignition is switched off,  
when the driver's door is opened and when the  
vehicle is locked or unlocked.  
21  
Instruments  
Total distance recorder  
Coolant temperature indicator  
For more information on Checking  
levels, refer to the corresponding  
section.  
Checking  
After driving for a few minutes, the temperature  
and pressure in the cooling system increase.  
To top up the level:  
► wait at least one hour for the engine to cool,  
► unscrew the cap by two turns to allow the  
pressure to drop,  
This measures the total distance travelled by the  
vehicle since its initial registration.  
Trip distance recorder  
► when the pressure has dropped, remove the  
cap,  
► top up the level to the "MAX" mark.  
For more information on Checking levels, refer  
to the corresponding section.  
This measures the distance travelled since it was  
last reset by the driver.  
Resetting the trip recorder  
With LCD symbols and LCD text or matrix  
instrument panel  
With the engine running:  
Be aware of the risk of scalding when  
topping up the coolant. Do not fill above  
the maximum level (indicated on the  
reservoir).  
– In zone A, the temperature is correct.  
– In zone B, the temperature is too high.  
The associated warning lamp and the  
STOP warning lamp light up in red on the  
instrument panel, accompanied by the display of  
a message and an audible signal.  
You must stop the vehicle as soon as it is  
safe to do so.  
Engine oil level indicator  
(Depending on version)  
On versions fitted with an electric gauge, the  
engine oil level status is displayed on the  
instrument panel for a few seconds when the  
ignition is switched on, at the same time as the  
servicing information.  
► With the ignition on, press the button until  
zeros appear.  
Wait a few minutes before switching off the  
engine.  
After switching off the ignition, carefully  
open the bonnet and check the coolant  
level.  
22