Advertisement

Advertisement

Practical information -> Energy economy mode for Your Citroen Berlingo SUV Third Generation (2018-2025)

Practical information  
► If the vehicle is locked, unlock it.  
The red indicator lamp in the flap goes out to  
confirm that the charging nozzle is unlocked.  
► In modes 2 and 3, remove the charging  
nozzle within 30 seconds.  
Accelerated charging, mode 3  
continue to use functions such as the audio and  
telematics system, dipped beam headlamps or  
courtesy lamps.  
7
The end of charging is indicated by the charging  
control unit and by the fixed lighting of the green  
indicator lamp in the flap.  
► Hang up the nozzle on the charging unit and  
close the charging flap.  
Selecting the mode  
A confirmation message is displayed when  
energy economy mode is entered, and the active  
functions are placed on standby.  
Superfast charging, mode 4  
The end of charging is indicated by the charger  
and by the fixed lighting of the green indicator  
lamp in the flap.  
You can also pause charging by  
pressing this button in the flap (in mode 4  
only).  
The locking of the nozzle is linked to the  
locking of the loading area. For more  
information on Complete or selective  
unlocking, refer to the corresponding  
section.  
If a telephone call is in progress at the  
time, it will be maintained for around 10  
minutes via the audio system’s hands-free  
system.  
The charging indicator lamp comes on in white.  
► Hang up the nozzle on the charger.  
► Depending on version, replace the protective  
cover on the lower section and close the  
charging flap.  
Exiting the mode  
With selective door unlocking activated,  
press the unlocking button twice to  
disconnect the charging nozzle.  
These functions are automatically reactivated the  
next time the vehicle is used.  
To restore the use of these functions  
When the charging nozzle is  
disconnected, a message on the  
instrument panel indicates that charging is  
complete, even if the charging nozzle was  
disconnected before full charging was  
completed.  
immediately, start the engine and let it run:  
– For less than 10 minutes, to use the  
equipment for approximately 5 minutes.  
– For more than 10 minutes, to use the  
equipment for approximately 30 minutes.  
Let the engine run for the specified duration to  
ensure that the battery charge is sufficient.  
To recharge the battery, avoid repeatedly or  
continuously restarting the engine.  
When charging is complete, the green  
charging indicator lamp in the flap goes  
out after about 2 minutes.  
Domestic charging, mode 2  
The end of charging is confirmed when the green  
CHARGE indicator lamp on the control unit and  
the green charging indicator lamp in the flap  
come on fixed.  
► Replace the protective cover on the charging  
nozzle and close the charging flap.  
Energy economy mode  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
This system manages the duration of use of  
certain functions, in order to conserve a sufficient  
level of charge in the battery with the ignition off.  
After switching off the engine and for a maximum  
cumulative period of around 30 minutes, you can  
► Disconnect the control unit end of the  
charging cable from the domestic socket.  
187