Driving
system), press one of the buttons 3-SET to
switch the speed limiter on.
►ꢀ Or pressing button 2-II> activates the
function.
When exceeding the speed is not due to the
driver's action (e.g. in case of a steep slope), an
audible signal is triggered immediately.
distance between vehicles, the driver
remains responsible for their driving.
In the interest of public safety, only use
6
cruise control if the traffic conditions enable
vehicles to drive at a steady speed and
maintain an adequate safety distance.
Remain vigilant while cruise control is
activated. If you press and hold one of the
speed setting modification buttons, your
vehicle may change speed very abruptly.
When descending a steep hill, the cruise
control system cannot prevent the vehicle
from exceeding the set speed. Brake if
necessary to control the vehicle speed.
On steep climbs or when towing, the set
speed may not be reached or maintained.
On a steep descent or in the event of
sharp acceleration, the speed limiter
will not be able to prevent the vehicle from
exceeding the speed setting.
If necessary, apply the brakes to control your
vehicle’s speed.
►ꢀ Pressing button 2-II> temporarily pauses the
function.
►ꢀ Pressing button 2-II> again resumes the
function.
When the vehicle speed returns to the speed
setting level, the speed limiter operates again:
the speed setting display becomes fixed again.
Adjusting the speed setting
Off
You do not have to switch the speed limiter on
in order to set the speed.
►ꢀ Press 1-MODE: the speed limiter information
To change the speed setting using the vehicle’s
current speed:
►ꢀ For steps of +/- 1 mph (1 km/h), make
successive short presses upwards/downwards
on 3 to increase/decrease.
►ꢀ For steps of +/- 5 mph (5 km/h), press and
hold upwards/downwards on 3 to increase/
decrease.
display disappears.
Exceeding the programmed speed
setting
Malfunction
You can temporarily exceed the speed
setting by pressing the accelerator pedal
(the programmed speed flashes).
To return to the speed setting, release the
accelerator pedal (when the set speed is
reached again, the displayed speed stops
flashing).
In the event of a malfunction, dashes are
displayed flashing and then fixed instead of the
speed setting.
Have it checked by a CITROËN dealer or a
qualified workshop.
Temporarily exceeding the
speed setting
Cruise control - Specific
recommendations
The cruise control function does not
guarantee compliance with the
maximum authorised speed and the safety
Operating limits
Never use the system in the following
situations:
– In an urban area with the risk of
pedestrians crossing the road.
►ꢀ Fully depress the accelerator pedal.
The speed limiter is temporarily deactivated
and the displayed speed setting flashes.
►ꢀ Release the accelerator pedal to return to
below the speed setting.
105
English 
