Lighting and visibility -> Changing a wiper blade for Your Citroen C3 Aircross SUV Second Generation (2024-2026)

Lighting and visibility  
Do not cover the rain/sunshine sensor.  
When using an automatic car wash,  
switch off the automatic wipers and the  
ignition.  
In winter, wait until the windscreen is  
completely clear of ice before activating the  
automatic wipers.  
must be reactivated by pushing the control  
stalk downwards.  
Operating the wiper control stalk immediately  
after switching off the ignition will place the  
wiper blades in a vertical position.  
►ꢀ Proceed with the desired operation or the  
replacement of the wiper blades.  
4
Malfunction  
If a fault occurs with the automatic wipers, the  
wipers operate in intermittent mode.  
Have it checked by a CITROËN dealer or a  
qualified workshop.  
After refitting a windscreen wiper blade  
►ꢀ To return the wiper blades to their initial  
position after the operation, switch on the  
ignition and operate the wiper control stalk.  
Switching on  
Special position of the  
windscreen wipers  
Changing a wiper blade  
Removing/Refitting at the front  
This maintenance position is used while  
cleaning or replacing the wiper blades. It can  
also be useful, in wintry weather (ice, snow), to  
release the wiper blades from the windscreen.  
►ꢀ Give a short downwards push to the control  
stalk.  
A wiping cycle confirms that the instruction has  
been accepted.  
To maintain the effectiveness of the  
flat wiper blades, it is advisable to:  
– handle them with care.  
– clean them regularly using soapy water.  
– avoid using them to hold cardboard on the  
windscreen.  
Depending on version, this indicator  
lamp lights up on the instrument panel,  
accompanied by a message.  
– replace them at the first signs of wear.  
Switching off  
►ꢀ Give the control stalk another brief push  
downwards or set the control stalk to another  
position (Int, 1 or 2).  
Before removing a windscreen wiper blade  
►ꢀ Carry out these wiper blade replacement  
operations from the driver's side.  
►ꢀ Starting with the wiper blade farthest from  
you, hold each arm by the rigid section and  
raise it as far as possible.  
Depending on version, this indicator  
lamp goes off on the instrument panel,  
accompanied by a message.  
If the ignition has been off for more  
than one minute, the automatic wipers  
59  
Lighting and visibility  
Take care not to hold the arms at the  
jet locations.  
Do not touch the wiper blades - risk of  
irreparable deformation.  
Do not release them while moving them.  
Risk of damaging the windscreen!  
►ꢀ Clean the windscreen using screenwash  
fluid.  
Do not apply "Rain X" type water-  
repellent products.  
►ꢀ Unclip the worn wiper blade closest to you  
and remove it.  
►ꢀ Install the new wiper blade and clip it to the  
arm.  
►ꢀ Repeat the procedure for the other wiper  
blade.  
►ꢀ Starting with the wiper blade closest to you,  
once again hold each arm by the rigid section,  
then guide it carefully onto the windscreen.  
Removing/refitting at the rear  
►ꢀ Hold the arm by the rigid section and raise it  
as far as possible.  
►ꢀ Clean the rear screen using screenwash  
fluid.  
►ꢀ Unclip the worn wiper blade and remove it.  
►ꢀ Install the new wiper blade and clip it to the  
arm.  
►ꢀ Once again hold the arm by the rigid  
section, then guide it carefully onto the rear  
screen.  
60