Lighting and visibility
This system is a driving aid.
The driver remains responsible for
the vehicle's lighting, its correct use in
the prevailing light, visibility and traffic
conditions, and for compliance with driving
and vehicle regulations.
If the ambient light level is sufficient and/or the
traffic conditions do not allow the main beam
headlamps to be lit:
– The dipped beam headlamps
remain lit. These indicator lamps
light up on the instrument panel.
The function is deactivated if the foglamps
are switched on or if the system detects
poor visibility conditions (e.g. fog, heavy rain,
snowfall).
When the foglamps are switched off or when
the visibility conditions become favourable
again, the function is automatically reactivated.
This indicator lamp goes out when the
function is deactivated.
up on the instrument panel, accompanied by an
audible signal and a message.
Have it checked by a CITROËN dealer or a
qualified workshop.
4
Wiper control stalk
Before operating the wipers in wintry
conditions, clear any snow, ice or frost
from the windscreen and around the wiper
arms and blades.
The system becomes operational
when the vehicle exceeds 28 mph
(45 km/h).
When the speed falls below 22 mph
(35 km/h), the system is no longer
operational.
Do not operate the wipers on a dry
windscreen. In extremely hot or cold
weather, check that the wiper blades are not
stuck to the windscreen before operating
the wipers.
Activation/Deactivation
Pause
The settings are changed via the instrument
panel menu, using the steering-mounted
controls.
If the situation requires a change of headlamp
beam, the driver can take over at any time.
►ꢀ Switch the headlamps manually between
dipped and main beam to pause the function.
If the "AUTO" and "Dipped beam" indicator
lamps were on, the system changes to main
beam.
After using an automatic car wash, you
may temporarily notice abnormal
noises and poorer wiping performance. You
do not need to replace the wiper blades.
The state of the system is stored when the
ignition is switched off.
When the system detects thick fog, it
temporarily deactivates the function.
If the "AUTO" and "Main beam" indicator lamps
were on, the system changes to dipped beam.
►ꢀ To reactivate the function, once again
switch the headlamps manually between
dipped and main beam.
Operation
If the ambient light level is very low and traffic
conditions permit:
– The main beam headlamps
come on automatically. These
indicator lamps light up on the instrument
panel.
Malfunction
If a malfunction occurs with the system
or the camera, this warning lamp lights
57
English 
