AUTOMATIC AIR CONDITIONING
AIR CONDITIONING
Air inlet
This system automatically adjusts the temperature, the
flow of air and the distribution of air inside the cabin,
depending on your desired comfort level.
Check that the exterior grille for the air inlet, at the
bottom of the windscreen, is clean and free of dead
leaves, snow, etc.
III
Provided you retain automatic mode (by pressing button
"AUTO") and all the air vents are open, you will main-
tain an optimum comfort level, also removing humidity
and misting, whatever the ambient climatic conditions.
If washing the vehicle with a high pressure jet, avoid
targeting the air inlet zone.
Air circulation
The temperature inside the cabin cannot be lower than
the temperature outside if the air conditioning is not
operating.
For your comfort we advise you to maintain a proper
distribution of air within the cabin, both at the front and
at the rear.
To be effective, the air conditioning should only be used
with the windows closed. If after a lengthy stop in bright
sunlight the interior temperature is excessive, air the
passenger compartment by opening the windows for a
few moments, then close them again.
To keep the air conditioning compressor well sealed,
it is essential to operate the air conditioning at least
once every month.
The air vents to the face have thumbwheels so that
you can adjust the flow of air, and grilles to orient the
direction.
There are air vents on the floor underneath the front
seats and on the rear control panel, for enhanced heat-
ing of the rear seat positions.
Do not obstruct the air outlets located in the boot area.
The air conditioning operates by using power from the
engine. This results in a slight increase in fuel con-
sumption.
Dust/pollen filter
There is a filter for excluding pollen and dust.
This filter has to be changed according to the vehicle
maintenance schedule. See "Maintenance and Warranty
Guide".
Sensors
The automatic regulation of the air conditioning inside
the cabin makes use of a number of sensors, relieving
you of the need to make adjustments, other than the
desired cabin temperature.
Take care not to obstruct sensor A.
86