Advertisement

Advertisement

Practical Information -> Towing the vehicle for Your Citroen Ds3 SUV Second Generation (2018-2025)

Energy economy mode  
Load reduction mode  
System which manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates  
certain functions, such as the air conditioning,  
the heated rear screen...  
System which manages the period of use of certain functions to conserve a sufficient level of  
charge in the battery.  
After the engine has stopped, you can still use functions such as the audio equipment, windscreen  
wipers, dipped beam headlamps, courtesy lamps, etc. for a maximum combined period of  
thirty minutes.  
Exiting economy mode  
These functions are reactivated automatically  
This period may be greatly reduced if  
the battery is not fully charged.  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
the next time the vehicle is driven.  
F
In order to resume the use of these  
functions immediately, start the engine and  
let it run for a few minutes.  
Switching to economy mode  
Once this period has elapsed, a message  
appears in the screen indicating that the  
vehicle has switched to economy mode and the  
active functions are put on standby.  
The time available to you will then be double  
the period for which the engine is left running.  
However, this period will always be between  
five and thirty minutes.  
If the telephone is being used at the  
same time, it will be interrupted after  
10 minutes.  
A flat battery prevents the engine from  
starting.  
227  
Practical information  
Changing a front or rear wiper blade  
Procedure for replacing a worn wiper blade with a new one without the use of tools.  
Before removing a front  
wiper blade  
Fitting  
F
At the front, check the size of the wiper  
blade as the shorter blade is fitted to the  
passenger side of the vehicle.  
Put the corresponding new wiper blade in  
place and clip it.  
F
Within one minute after switching off the  
ignition, operate the wiper stalk to position  
the wiper blades in the vertical position.  
F
F
This position must be used in order to avoid  
damaging the wiper blade and the bonnet.  
Fold down the wiper arm carefully.  
Removal  
After fitting a front wiper  
blade  
F
Raise the corresponding wiper arm.  
F
Unclip the wiper blade and remove it.  
F
Switch on the ignition.  
F
Operate the wiper stalk again to park the  
wiper blades.