Advertisement

Advertisement

Ease of use and comfort -> Boot fittings for Your Citroen Spacetourer Van First Generation (2019-2024)

Ease of use and comfort  
12 V accessory socket  
Rear shelf  
Boot fittings  
3
To remove the shelf:  
F release the two cords,  
F To connect a 12 V accessory (max power:  
120 Watts), lift the cover and connect  
a suitable adaptor.  
F gently lift the shelf, then remove it.  
There are several ways of storing it:  
-
-
either upright behind the front seats,  
or flat on the bottom of the boot.  
1. Rear shelf  
(see details opposite)  
Do not exceed the maximum power rating  
of the socket (risk of damage to your  
device).  
2. Hooks  
(see details opposite)  
3. Strap  
Hooks  
4. Stowing rings  
5. 12 V socket (max power: 120 Watts)  
The connection of an electrical device  
not approved by CITROËN, such as  
a USB charger, may adversely affect the  
operation of vehicle electrical systems,  
causing faults such as poor radio  
reception or interference with displays in  
the screens.  
These can be used to secure shopping bags.  
85  
Ease of use and comfort  
Load space cover  
Boot fittings  
The mobile flap avoids interference with  
the second row passengers when the  
seats are in the "comfort" position.  
In 5-seat configuration, it is installed behind  
the second row seats, with the third row seats  
stored folded away.  
Removal  
In 7-seat configuration, it is stored behind the  
third row seats.  
Installation  
1. Load space cover  
2. Concertina boards  
3. 12 V socket (max power: 120 Watts)  
F Remove the guides of the roller from the  
rails in pillars B.  
4. Armrest with cup holder and storage  
compartment  
F Guide the roller as it reels in.  
F Unlock the roller by pressing one of the  
handles located at the ends of the roller  
bracket.  
5. Storage area of the load space cover  
6. Open storage compartment  
7. Low stowing rings  
F Position the left and right ends of the roller  
in cut-outs A, with the mobile flap at the  
front.  
F Pull out the roller until it reaches the boot  
pillars.  
F Insert the guides of the roller into the rails in  
pillars B.  
86  
Ease of use and comfort  
1. Front courtesy lamp  
Storage behind the 3rd row seats  
When sharp deceleration occurs, objects  
placed on the load space cover can turn  
into projectiles.  
2. Front map reading lamps  
3. Rear courtesy lamp  
4. Rear map reading lamps  
Front – rear courtesy lamps  
Courtesy lamps  
In this position, the courtesy lamp  
comes on gradually:  
3
-
-
when you unlock the vehicle,  
when the electronic key is removed from the  
reader,  
-
-
when opening a door,  
when the remote control locking button is  
activated, in order to locate your vehicle.  
F Make sure that the 3rd row seats are folded.  
F Fold the first two concertina boards.  
F Position the roller in the space located  
above the armrest, side by side, tilting it  
slightly.  
It will only be possible to switch on the door  
mirror spotlamps if the courtesy lamp is in this  
position.  
F Slide the roller to the stop position, until it  
reaches the notches arranged at the back of  
the boot, with the two hinges facing down.  
F Unfold the third row seats.  
The folded concertina boards can be placed in  
the horizontal or upright position.  
It switches off gradually:  
-
-
-
when the vehicle is locked,  
when the ignition is switched on,  
30 seconds after the last door is closed.  
Permanently off.  
To fold the 3rd row seats with the roller stored at  
the back, it is necessary to raise the concertina  
boards in order to give access to the seat  
unlocking controls (red straps).  
Permanent lighting.  
87