In the event of a breakdown
F Put the cover back in place and clip it in.
F Close the bonnet.
BlueHDi 130 S&S and
Running out of fuel
(Diesel)
On vehicles fitted with Diesel engines, the fuel
system must be primed if you run out of fuel.
For all versions other than BlueHDi, refer to the
corresponding engine compartment view.
BlueHDi 160 S&S engines
F Fill the fuel tank with at least 5 litres of
Diesel.
F Switch on the ignition (without starting the
engine).
F Wait around 1 minute and switch off the
ignition.
F Operate the starter to run the engine.
If the engine does not start, repeat the
procedure.
For more information on Diesel misfuel
prevention, refer to the corresponding
section.
Other engines
If the engine does not start first time, do
not keep trying but start the procedure
again from the beginning.
F Fill the fuel tank with at least 5 litres of
Diesel.
F Open the bonnet.
F If necessary, unclip the cover to access the
priming pump.
BlueHDi 100 S&S, BlueHDi
115/120 S&S and BlueHDi
135/150 S&S engines
F Fill the fuel tank with at least 5 litres of
Diesel.
F
Operate the priming pump
repeatedly until resistance is felt
(there may be resistance on the
first press).
F Switch on the ignition (without starting the
engine).
F Wait around 6 seconds and switch off the
ignition.
F Repeat the operation 10 times.
F Operate the starter to run the engine.
F Operate the starter to start the engine (if the
engine does not start at the first attempt,
wait around 15 seconds before trying
again).
F If the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
236
English 
