Get In the event of a breakdown -> Temporary puncture repair kit Guide for Citroen Spacetourer Van First Generation (2019-2024)

In the event of a breakdown

Placing the triangle on the

road

Access to the kit

Warning triangle

This safety device is used in addition to the

F Place the triangle behind the vehicle, as

required by the legislation in force in your

country.

hazard warning lamps.

Its presence in the vehicle may be mandatory.

Temporary puncture

repair kit

Scan the QR code on page 3 to view

explanatory videos.

Comprising a compressor and a sealant

cartridge, it allows the temporary repair of

a tyre so that you can drive to the nearest

garage.

It is designed to repair most punctures which

could affect the tyre, located on the tyre tread

or shoulder.

The kit is stowed in a bag inside the storage

box located at the foot of the second row

passenger seat.

A space is provided for the storage of the

triangle in the interior trim of the tailgate.

Before leaving your vehicle to set up and

install the triangle, switch on the hazard

warning lamps and put on your high

visibility vest.

The vehicle's electric system allows the

connection of the compressor for long

enough to inflate a tyre after a puncture

repair.

Refer to the instructions on assembly/

unfolding indicated in the user guide

supplied with the triangle.

208

In the event of a breakdown

F Remove the valve cap from the tyre to be

Composition of the kit

repaired, and place it in a clean area.

F Connect the pipe from the compressor to

1. 12 V compressor, with built-in pressure

the bottle of sealant.

gauge.

2. Bottle of sealant, with built-in hose.

3. Speed limit sticker.

Avoid removing any foreign bodies which

have penetrated into the tyre.

F Connect the hose from the bottle of sealant

to the valve of the tyre to be repaired and

tighten firmly.

F Check that the compressor switch is at the

"O" position.

Repair procedure

F Park the vehicle without obstructing any

traffic and apply the parking brake.

F Follow the safety instructions (hazard

warning lamps, warning triangle, wearing

high visibility vest, etc.) according to the

legislation in force in the country where you

are driving.

F Uncoil fully the electric cable, stowed under

the compressor.

F Connect the compressor's electric plug to

the vehicle's 12 V socket.

Only the 12 V socket located at the front of

the vehicle can be used.

8

F Switch off the ignition.

F Uncoil the pipe stowed under the

compressor.

F

Affix the speed limit sticker.

F Turn the sealant bottle over and secure it in

the notch provided on the compressor.

209

In the event of a breakdown

The speed limit sticker must be secured

to the interior of the vehicle in the driver's

field of vision, to remind you that a wheel

is in temporary use.

If a pressure of 2 bars is not reached after

about 7 minutes, this indicates that the

tyre is not repairable; contact a CITROËN

dealer or a qualified workshop for

assistance.

F Place the switch in the "O" position.

F Disconnect the compressor's electric plug

from the vehicle's 12 V socket.

F Replace the cap on the valve.

F Remove the kit.

F Drive immediately for approximately three

miles (five kilometres), at reduced speed

(between 12 and 37 mph (20 and 60 km/h)),

to plug the puncture.

The tyre inflation pressures are given on

this label.

F Stop to check the repair and measure the

tyre pressure using the kit.

F Remove and then store the bottle of sealant.

F Switch on the ignition.

Do not exceed the speed of 50 mph

(80 km/h) when driving with a tyre repaired

using this type of kit.

Take care, the sealant product is harmful

if swallowed and causes irritation to the

eyes.

Keep this product out of the reach of

children.

The use-by date of the fluid is marked on

the bottle.

Checking/adjusting tyre

pressures

After use, do not discard the bottle in

standard waste, take it to a CITROËN

dealer or an authorised waste disposal

site.

Do not forget to obtain a new bottle of

sealant, available from a CITROËN dealer

or a qualified workshop.

You can also use the compressor,

without injecting sealant, to check and, if

necessary, adjust the tyre pressures.

F Start the compressor by turning the switch

to the "l" position until the pressure of the

tyre reaches 2.0 bars. The sealant product

is injected under pressure into the tyre;

do not disconnect the pipe from the valve

during this operation (risk of blowback).

F Remove the valve cap from the tyre and

place it in a clean area.

210

In the event of a breakdown

F Uncoil the pipe stowed under the

F Start the compressor by placing the switch

at position "I" and adjust the pressure to the

value shown on the vehicle's tyre pressure

label. To deflate: press the black button

located on the compressor pipe, near the

valve connection.

Spare wheel

compressor.

Procedure for changing a wheel with

a damaged or punctured tyre for the spare

wheel using the tools provided with the vehicle.

If a pressure of 2 bars is not reached after

7 minutes, this indicates that the tyre is

not repairable; contact a CITROËN dealer

or a qualified workshop for assistance.

Scan the QR code on page 3 to view

explanatory videos.

F Screw the pipe onto the valve and tighten

firmly.

F Check that the compressor switch is at the

"O" position.

Access to tooling

F Once the correct pressure is reached, put

the switch to the "O" position.

F Remove the kit then stow it.

F Uncoil fully the electric cable, stowed under

the compressor.

F Connect the compressor's electric plug to

the vehicle's 12 V socket.

F Switch on the ignition.

Do not drive more than 125 miles (200 km)

with the repaired tyre; see a CITROËN

dealer or a qualified workshop to change

the tyre.

Only the 12 V socket located at the front

of the vehicle can be used to power the

compressor.

Should the pressure of one or more tyres

be adjusted, it is necessary to reinitialise

the under-inflation detection system.

For more information on Tyre under-

inflation detection, refer to the

corresponding section.

The tools are installed in the boot under the

floor.

Remove the boot carpet to access them.

8

The tyre inflation pressures are given on

this label.

211

In the event of a breakdown -> Temporary puncture repair kit for Your Citroen Spacetourer Van First Generation (2019-2024)

Related Topics

In the event of a breakdown

Popular Owner Manuals

Latest Owner Manuals