2024-2026 Cupra Terramar SUV Air conditioning -> Auxiliary heating (additional heating) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Air conditioning -> Auxiliary heating (additional heating) for Your Cupra Terramar SUV First Generation (2024-2026)

Air conditioning
155
Auxiliary heating (additional heating)
1)
Availability depending on the equipment.
Auxiliary heating (addi-
tional heating)
Introduction
The auxiliary heater
1)
runs on fuel from the
vehicle's tank and can be used while you are
driving and when the vehicle is stationary.
The auxiliary heater can be controlled through
the auxiliary heating menu in the Infotainment
system, through the My CUPRA App or with the
remote control.
In winter, with the auxiliary heater switched on,
you can demist the windscreen and leave it
free of ice and snow (if it is a thin layer) before
you start driving.
If the outside temperature is very high, the ve-
hicle interior can be ventilated with the engine
o using the auxiliary heater.
The maximum operating period of the parking
ventilation is 60 min.
WARNING
The exhaust gases from auxiliary heating
contain carbon monoxide, a toxic, colourless
and odourless gas. Carbon monoxide can
cause loss of consciousness and death.
●
Never switch on the auxiliary heater or
leave it running in enclosed spaces or areas
with no ventilation.
●
Never program the auxiliary heating to
switch on and operate in an enclosed or un-
ventilated space.
●
Before refuelling, switch o the additional
heating.
WARNING
The components of the auxiliary heater are
extremely hot and could cause a re.
●
Always park your vehicle so that no part
of the exhaust system can come in contact
with easily ammable materials that might be
below the vehicle, such as dried grass.
NOTICE
Never place food, medicines or other tem-
perature-sensitive objects close to the air
vents. Food, medicines and other objects
sensitive to heat or cold may be damaged or
made unsuitable for use by the air coming
from the vents.
Switching the auxiliary heater on
and o
Connection
The auxiliary heating can be switched on in the
following ways:
●
Press the immediate on/o button in the My
CUPRA App.
●
Press the immediate on/o button in the
infotainment system’s departure menu (with
the vehicle switched o) or the on/o button
in the infotainment system’s auxiliary heating
menu (with the vehicle switched on).
●
Press button on the remote control
›››page156.
●
Automatically scheduling a departure time in
the auxiliary heater menu in the infotainment
system or in My CUPRA App ›››page157.
Disconnection
The auxiliary heating can be switched o in the
following ways:
●
The auxiliary heating function can be turned
o immediately using the immediate on/o
button in My CUPRA App.
●
Press the immediate on/o button in the
infotainment system’s departure menu (with
the vehicle switched o) or the on/o button
in the infotainment system’s auxiliary heating
menu (with the vehicle switched on).
156
Air conditioning
1
●
Press button on the remote control
›››page156.
●
Automatically at the scheduled departure
time or after the programmed operating time
has elapsed .
●
Automatically when the control lamp (fuel
level indicator) lights up.
●
Automatically when the 12-volt battery
charge drops too low ›››page365.
Setting the desired temperature
●
Open the infotainment system’s Auxiliary
heating menu.
●
Set the desired temperature using and .
Things to note
Once switched o, the auxiliary heater will
continue to operate for a short period of time
in order to burn the fuel remaining in the sys-
tem and also to expel the exhaust fumes.
Radio-operated remote control
Fig.114 Auxiliary heating: radio remote
control.
›››
Fig.114
Switch the auxiliary heater on
Switch the auxiliary heater o
Control lamp.
If the buttons on the remote control are
pressed unnecessarily, the auxiliary heating
may be switched on unintentionally, even if you
are outside the operating range or the control
lamp is ashing.
To switch on and o the independent heating,
the button must be pressed and held for ap-
proximately 1 second.
Control lamp on the remote control
When the buttons are pressed, the control
lamp on the remote control
1
provides the
user with dierent information:
It lights up for approx. 2 seconds
●
In green: The auxiliary heater has been
switched on using the button.
●
In red: The auxiliary heater has been
switched o using the button.
Flashes slowly for approx. 2 seconds
●
In green: No on signal has been received.
The remote control is out of range. Move
closer to the vehicle.
●
In red: No o signal has been received. The
remote control is out of range. Move closer to
the vehicle.
Flashes quickly approx. 2 seconds
●
In green: The independent heating is
blocked. Possible causes: the fuel tank is al-
most empty, the 12-volt battery charge is very
low or there is a fault.
It lights up for approx. 2 seconds
●
In orange (then in green or in red): The
battery in the remote control is almost empty.
However, the on or o signal was received.
●
In orange (then ashes green or red): The
battery in the remote control is almost empty.
No on or o o signal has been received.
Air conditioning
157
Auxiliary heating (additional heating)
Flashes for around 5 seconds
●
In orange: The battery in the remote control
is at. No on or o o signal has been received.
Changing the battery of the radio-operated
remote control
When pressing the buttons, if the control lamp
of the remote
1
ashes for approx. 5 orange
or does not light up, the batteries must be re-
placed.
The battery is located beneath a cover on the
back of the remote control.
●
To open the cover, lift it slightly at the bot-
tom and slide it down.
●
Remove the battery.
●
Insert the new battery. When doing so, take
into account the polarity and use batteries of
the same type››› .
●
Replace the battery cover by inserting the
tabs at the top and pressing the bottom.
Range
The receiver is inside the vehicle. The remote
control, when tted with new batteries, has
a range of several hundred metres. Obstacles
between the remote control and the vehicle,
bad weather conditions and discharged bat-
teries can considerably reduce the range of
the remote control.
WARNING
Swallowing a battery with a diameter of 20
mm or any other button battery can cause
serious injuries or even death within a very
short time.
●
Always keep the radio remote control and
key fobs containing batteries, as well as spare
batteries, button cells and other batteries
larger than 20 mm, out of the reach of chil-
dren.
●
If you suspect that someone may have
swallowed a battery, seek medical attention
immediately.
NOTICE
●
The remote control contains electronic
components. Therefore, avoid getting it wet
and avoid impacts or direct sunlight.
●
The use of unsuitable batteries may dam-
age the remote control. Therefore, always re-
place the old battery with a new one of the
same voltage, size and specication.
For the sake of the environment
●
Dispose of used batteries in an environ-
mentally friendly manner.
●
The remote control battery may contain
perchlorate. Please observe the legal provi-
sions regarding its disposal.
●
Make sure that it is not possible to operate
the remote control unintentionally in order
to avoid switching on the auxiliary heating
without intending to.
Programming the auxiliary heater
The activation of the parking ventilation for a
scheduled time is only valid for a single ventila-
tion process. The departure time must be for
each newly programmed ventilation process.
Before programming the departure time, you
must check that the date and time of the vehi-
cle are correctly set.
When programming a departure time, the ve-
hicle automatically calculates, depending on
the environmental conditions, the necessary
operating time of the parking ventilation.

Related Topics

Popular Owner Manuals