General instructions for
use
Operating indications
●
The infotainment system needs a few sec-
onds to start up completely and during that
time it does not react to inputs. Only the im-
age of the rear view camera system can be dis-
played during system start-up.
●
The display of all indications and the execu-
tion of functions only takes place once the in-
fotainment system has nished booting. The
duration of the system boot depends on the
number of infotainment functions and may
take longer than normal in the event of very
high or very low temperatures.
●
When using the infotainment system and
corresponding accessories, e.g., headphones,
bear in mind country-specic regulations and
legal provisions.
●
Some functions of the infotainment system
require an active CUPRA CONNECT user ac-
count and an Internet connection for the vehi-
cle. Data transmission must not be limited for
functions to be performed.
●
To use the infotainment system, simply lightly
press a button or touch the screen.
●
For the correct operation of the infotain-
ment system it is important that it is switched
on and that, if necessary, the time and date of
the vehicle are set correctly.
●
If a function button is missing on the screen,
it is not a device defect, but corresponds to the
specic equipment of the country or version.
●
Some infotainment functions can only be se-
lected when the vehicle is at a standstill. In
some countries the parking lock must also be
enabled (button P ) or the selector control
must be in the neutral position N. This is not
a malfunction, but is due to compliance with
legislation.
●
Restrictions on the use of devices using
Bluetooth® technology may apply in some
countries. For further information, contact the
local authorities.
●
If you disconnect the 12-volt battery, turn on
the ignition before restarting the infotainment
system.
●
If the setup is changed, this may change the
display on the screen and in some cases, the
infotainment system may behave in a manner
dierent to that described in this instruction
manual.
●
In some countries, the infotainment system
automatically shuts o when the engine is
switched o and the vehicle's 12-volt battery
charge level is low.
●
Ensure that any repairs or modications that
need to be carried out on the infotainment
system are carried out by a specialised work-
shop. CUPRA recommends going to a special-
ised CUPRA dealer or any SEAT dealership for
this purpose.
●
Using a mobile phone device inside the vehi-
cle may cause noise in the speakers.
●
On vehicles with park assist, the audio
source volume is automatically lowered when
reverse gear is selected. The volume reduction
can be adjusted.
●
Information about the included software and
the license conditions can be found in Set-
tings > Information > Copyright.
●
When selling or lending the vehicle, make
sure that all saved data, les and settings have
been deleted and, if necessary, external audio
sources and data media have been removed.
Note
You can nd more information and tips for
using the infotainment system in the Help
menu.
Home screen
If an icon is missing on the screen, it is not a
device defect, but corresponds to the specic
equipment of the country or version.
The following menus can be included as an
icon:
Main menus
Vehicle ›››page39
Navigation ›››page300