2024-2026 Cupra Terramar SUV Seats and headrests User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seats and headrests for Your Cupra Terramar SUV First Generation (2024-2026)

124
Seats and headrests
1
2
3
4
Seats and headrests
Front seats
Introduction
WARNING
Always read and observe the information and
safety advice given in chapter ›››page44,
Correct sitting position of vehicle occu-
pants.
WARNING
Incorrect seat adjustment may lead to acci-
dents and severe injuries.
●
Only adjust the seats when the vehicle
is stationary, as the seats could move unex-
pectedly while the vehicle is in motion and
you could lose control of the vehicle. Fur-
thermore, an incorrect position is adopted
when adjusting the seat.
●
Adjust the height, position and inclination
of the front seats only when their movement
area is empty.
●
Make sure there are no objects in that area.
●
Make sure that the movement and locking
areas of the seats are clean.
WARNING
Incorrectly using upholstery and seat cov-
ers might cause an accidental activation of
the electrical seat adjustment system and
make it move unexpectedly while driving.
This might cause loss of control of the vehi-
cle and thus accidents or injuries. Moreover,
the electrical components of the front seats
might be damaged.
●
Never attach or place seat upholstery or
covers on the electric controls.
●
Never use upholstery or seat covers that
have not been explicitly authorised for the
seats of the vehicle.
NOTICE
Objects with sharp edges can damage the
seats.
●
Do not rub the seats with sharp objects.
Sharp objects, such as zips and rivets on
clothing or belts, can damage surfaces. Open
Velcro fasteners can also cause damage.
NOTICE
When adjusting the seat, take care to avoid
the headrest impacting against the roof. Risk
of damage!
Manual adjustment of the front
seats
Fig.94 Front seats: manual seat
adjustment.
Pull the lever to move the seat forwards
or backwards. The seat must engage when
the lever is released!
Move the lever up or down to adjust the
seat height; several times if necessary.
Without placing force on the seat back-
rest, turn the wheel to adjust the backrest.
To adjust the lumbar support, move the
lever until the required position is ach-
ieved.
Seats and headrests
125
Rear seats
A
B
C
Electric adjustment of the front
seats
Fig.95 Driver's seat: electric seat
adjustment.
Adjust the lumbar support: press the but-
ton according to the desired position.
Seat forwards/backwards: press the button
forwards/backwards.
Seat up/down: Press the rear part of the
button up/down. To adjust the angle of
the seat cushion, press the front of the
button up/down.
Backrest further upright/further reclined:
press the button forwards/backwards.
The position will be saved automatically in the
CUPRA CONNECT Active user when the igni-
tion is switched o.
WARNING
Using the electric front seats carelessly or
without paying due attention can cause seri-
ous injury.
●
The front seats can also be electrically
adjusted when the ignition is switched o.
Never leave a child or any other person who
may need help in the vehicle.
●
In the event of an emergency, electrical
adjustment can be stopped by pressing any
control.
NOTICE
To avoid damaging the electrical compo-
nents of the seats, please refrain from kneel-
ing on the seat or applying sharp pressure at
a single point to the seat cushion and back-
rest.
Note
●
It may not be possible to electrically adjust
the seat if the vehicle battery is very low.
●
If the engine is started while the seats are
being electrically adjusted, the adjustment
will stop.
Note
When changing user a warning will be shown
on the infotainment system's screen during
the time that the seat is moving to the saved
position. This movement can be stopped by
pressing the stop button on the screen.
Rear seats
Folding down and raising the rear
seat backrest
Fig.96 Rear seat: folding down the backrest.
The rear seat backrest is split and each part
can be lowered separately to enlarge the lug-
gage compartment.
126
Seats and headrests
1)
On seats with adjustable headrests.
Folding the backrest forwards
●
Fully lower the rear headrests ›››page127.
●
Pull the cord ›››Fig.96 forward in the direc-
tion of the arrow while holding the seat back-
rest and move it forward slowly››› .
●
Press the backrest down with your hand until
it locks.
Converting the table to a seat
●
Unlock the seat backrest with the cord. The
backrest disengages from its position.
●
Without letting go of the cord, lift the back-
rest.
●
Make sure that the seat belt is not trapped.
●
Press the backrest rmly into the lock until it
engages ››› .
●
The backrest must be properly engaged.
●
If necessary, adjust the headrest.
WARNING
Serious injuries can be caused if the rear seat
backrest is lowered or lifted without due care
and attention.
●
Never lower or lift the rear seat backrest
while driving.
●
Do not trap or damage the seat belt when
raising the rear seat backrest.
●
When lowering or lifting the rear seat back-
rest, keep your hands, ngers, feet and other
body parts out of its path.
●
For the rear seat belts to oer the nec-
essary protection, all the parts of the rear
backrest must be properly engaged. This is
particularly important in the case of the cen-
tre rear seat. If someone is seated in a seat
whose backrest is not properly engaged they
will y forward, along with the backrest, dur-
ing an accident or a sudden driving or brak-
ing manoeuvre.
●
A red mark on button
2
warns that the
rear backrest is not engaged. Always check
that the red marking is not visible when the
backrest is in the upright position.
●
When the rear seat backrest is lowered or is
not properly engaged nobody else may travel
in the corresponding seats (not even a child).
NOTICE
If the belts are caught when the seatback
is raised, fold the seatback back down to re-
lease the belt. Grab the belt with your hand
and lift the backrest so that it is not trapped.
NOTICE
Serious damage can be caused to the vehicle
and other objects if the rear seat backrest is
lowered or lifted without due care and atten-
tion.
●
Before lowering the rear seat backrest, al-
ways adjust the front seats so that neither
the headrests nor the cushions of the rear
backrest can hit them.
Headrest
Introduction
The headrest adjustment and removal options
are described below. Always make sure that
the seats are correctly adjusted ›››
page44.
All seats are tted with a headrest. The central
rear headrest is only intended for the central
seat of the rear bench. Therefore, do not install
it on any other seat.
Correct adjustment of the headrest
1)
Adjust the headrest so that its upper edge is
at the same level as the top of your head, as
close as possible to eye level. Keep the back of
your head always as close to the headrest as
possible.
Seats and headrests
127
Headrest
WARNING
If travelling with the headrests removed or
improperly adjusted, the risk of severe or fa-
tal injuries in the event of accidents and sud-
den braking or manoeuvres increases.
●
Always travel with the headrest correctly
installed and adjusted.
●
To decrease the risk of neck injuries in the
event of an accident, adjust the headrest
correctly based on your height, always mak-
ing sure that its upper edge is at the same
height as the top of the head, as close as pos-
sible to eye level. Keep the back of your head
always as close to the headrest as possible
and centred.
●
Never adjust the headrest while the vehicle
is in motion.
●
Under no circumstances should the rear
passengers travel while the headrests are in
the non-use position.
NOTICE
When assembling and disassembling the
headrests, do not allow them to come into
contact with the vehicle's ceiling liner, the
back rest of the front seat or other parts of
the vehicles. Any such contact could damage
the vehicle.
Adjusting the headrests
Fig.97 Rear headrest: adjusting the
headrest.
Adjusting the height of the headrests
●
Grab the sides of the headrests with both
hands and push upwards to the desired posi-
tion. To lower it, repeat the same action, press-
ing the button on the side
1
›››
Fig.97.
●
The headrest must lock correctly in one po-
sition.
Removing and tting the headrests
Fig.98 Rear headrest: removal.
Removing the rear headrests
To remove the headrest, the corresponding
backrest must be partially folded forward.
●
Unlock the backrest ›››page125.
●
Move the headrest upwards to its highest po-
sition.
●
Press button ›››Fig.98
1
, while simultane-
ously pressing on the safety hole
2
with a at
screwdriver a maximum of 5 mm wide, and re-
move the headrest.
●
Move the backrest until it engages properly.
Fitting the rear headrests
To mount the external headrests, the corre-
sponding backrest must be partially folded for-
ward.
128
Seats and headrests
1)
Not available in all markets.
●
Unlock the backrest ›››page125.
●
Insert the headrest bars into the guides until
they are heard to engage. It should not be pos-
sible to remove the headrest from the back-
rest.
●
Move the backrest until it engages properly.
WARNING
Remove the rear headrests only when it is
necessary to t a child seat. After removing a
child seat, ret the headrest immediately.
Seat functions
Memory function
Fig.99 On the outer side of the driver's
seat: memory buttons.
Memory buttons
The memory buttons can be used to save and
activate settings for the driver seat and exterior
mirrors.
The settings will also be saved in the user of
the online services
1)
.
Save the settings for the driver seat and ex-
terior mirrors for forward gear
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Adjust the driver seat and exterior mirrors.
●
Press for longer than 1 second ›››Fig.99.
●
Press the memory button in which to store
the settings within approx. 10 seconds. An
audible signal conrms that they have been
saved.
Save the settings of the front passenger ex-
terior mirrors for reversing.
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Press whichever memory button you want.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge
well.
●
The set position for the mirrors is automati-
cally saved and assigned to the key with which
you unlocked the vehicle.
Activating the settings
●
With the vehicle stopped and the ignition
switched on, press and hold the correspond-
ing memory button until the saved position is
reached.
●
OR: With the ignition switched o and the
driver's door open, briey press the corre-
sponding button.
The front passenger side exterior mirror auto-
matically changes from the position stored for
reversing as soon as the vehicle moves forward
at a speed of at least 15km/h (10mph) or
when the gear selection lever is changed to a
position other than R ›››page142.
Initialising the seat position memory
If, for example, the driver seat has been re-
placed, the position memory system must be
restarted.
Restarting deletes all memories and assign-
ments of seats with memory functions. The
memory keys can then be programmed again.
Seats and headrests
129
Seat functions
●
Open the driver's door and do not get into
the vehicle.
●
Change the seat settings from outside.
●
Tilt the backrest fully forward.
●
Release the control to adjust the inclina-
tion and press it again until an audible signal
sounds.
Easy Entry function
Depending on the equipment, the Easy Entry
function makes it easier for the driver to enter
and exit by moving the seat forwards or back-
wards respectively.
The function is activated via the driver setting
in the sub-menu of seat settings in the seats
menu of the infotainment system.
WARNING
Only set the memory function when the ve-
hicle is stationary.
Note
If the driver's door is opened approx. 10 mi-
nutes after the vehicle was unlocked or later,
the driver seat and the exterior mirrors do
not move automatically.
Front centre armrest
Fig.100 Front centre armrest
To raise the armrest, pull it fully up in the direc-
tion of the arrow ›››
Fig.100 or step by step,
depending on how far you want to raise it.
To lower the armrest, rst lift it to its highest
position. Then lower it down.
To move the armrest horizontally, move it for-
ward ›››Fig.100 or backward as much as
possible in the direction of the corresponding
arrow.
WARNING
The front centre armrest may obstruct the
driver's arm movements, which could cause
an accident and severe injuries.
●
Keep the storage compartments of the
centre armrest closed at all times while the
vehicle is in motion.
●
Never let anyone sit on the centre arm-
rest while the vehicle is in motion, not even
a child. This position is incorrect and may
cause severe injuries.
Rear centre armrest
Fig.101 Folding rear centre armrest.
There might be a folding armrest in the rear
centre seat.
●
To lower the armrest, pull the cord in the
direction of the arrow ›››Fig.101.
●
To raise the armrest, push it up in the oppo-
site direction to the arrow and press it as far as
it will go into the seat backrest.
When the centre armrest is down, do not allow
anybody to travel in the centre seat of the rear
bench.
130
Seats and headrests
WARNING
To decrease the risk of injuries while driv-
ing, the rear centre armrest must always be
raised.
●
When the centre armrest is down, nobody
may travel in the centre rear seat, not even a
child. An incorrect sitting position may cause
severe injuries.

Related Topics

Popular Owner Manuals