2024-2026 Cupra Terramar SUV Seats and headrests -> Headrest User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seats and headrests -> Headrest for Your Cupra Terramar SUV First Generation (2024-2026)

126
Seats and headrests
1)
On seats with adjustable headrests.
Folding the backrest forwards
●
Fully lower the rear headrests ›››page127.
●
Pull the cord ›››Fig.96 forward in the direc-
tion of the arrow while holding the seat back-
rest and move it forward slowly››› .
●
Press the backrest down with your hand until
it locks.
Converting the table to a seat
●
Unlock the seat backrest with the cord. The
backrest disengages from its position.
●
Without letting go of the cord, lift the back-
rest.
●
Make sure that the seat belt is not trapped.
●
Press the backrest rmly into the lock until it
engages ››› .
●
The backrest must be properly engaged.
●
If necessary, adjust the headrest.
WARNING
Serious injuries can be caused if the rear seat
backrest is lowered or lifted without due care
and attention.
●
Never lower or lift the rear seat backrest
while driving.
●
Do not trap or damage the seat belt when
raising the rear seat backrest.
●
When lowering or lifting the rear seat back-
rest, keep your hands, ngers, feet and other
body parts out of its path.
●
For the rear seat belts to oer the nec-
essary protection, all the parts of the rear
backrest must be properly engaged. This is
particularly important in the case of the cen-
tre rear seat. If someone is seated in a seat
whose backrest is not properly engaged they
will y forward, along with the backrest, dur-
ing an accident or a sudden driving or brak-
ing manoeuvre.
●
A red mark on button
2
warns that the
rear backrest is not engaged. Always check
that the red marking is not visible when the
backrest is in the upright position.
●
When the rear seat backrest is lowered or is
not properly engaged nobody else may travel
in the corresponding seats (not even a child).
NOTICE
If the belts are caught when the seatback
is raised, fold the seatback back down to re-
lease the belt. Grab the belt with your hand
and lift the backrest so that it is not trapped.
NOTICE
Serious damage can be caused to the vehicle
and other objects if the rear seat backrest is
lowered or lifted without due care and atten-
tion.
●
Before lowering the rear seat backrest, al-
ways adjust the front seats so that neither
the headrests nor the cushions of the rear
backrest can hit them.
Headrest
Introduction
The headrest adjustment and removal options
are described below. Always make sure that
the seats are correctly adjusted ›››
page44.
All seats are tted with a headrest. The central
rear headrest is only intended for the central
seat of the rear bench. Therefore, do not install
it on any other seat.
Correct adjustment of the headrest
1)
Adjust the headrest so that its upper edge is
at the same level as the top of your head, as
close as possible to eye level. Keep the back of
your head always as close to the headrest as
possible.
Seats and headrests
127
Headrest
WARNING
If travelling with the headrests removed or
improperly adjusted, the risk of severe or fa-
tal injuries in the event of accidents and sud-
den braking or manoeuvres increases.
●
Always travel with the headrest correctly
installed and adjusted.
●
To decrease the risk of neck injuries in the
event of an accident, adjust the headrest
correctly based on your height, always mak-
ing sure that its upper edge is at the same
height as the top of the head, as close as pos-
sible to eye level. Keep the back of your head
always as close to the headrest as possible
and centred.
●
Never adjust the headrest while the vehicle
is in motion.
●
Under no circumstances should the rear
passengers travel while the headrests are in
the non-use position.
NOTICE
When assembling and disassembling the
headrests, do not allow them to come into
contact with the vehicle's ceiling liner, the
back rest of the front seat or other parts of
the vehicles. Any such contact could damage
the vehicle.
Adjusting the headrests
Fig.97 Rear headrest: adjusting the
headrest.
Adjusting the height of the headrests
●
Grab the sides of the headrests with both
hands and push upwards to the desired posi-
tion. To lower it, repeat the same action, press-
ing the button on the side
1
›››
Fig.97.
●
The headrest must lock correctly in one po-
sition.
Removing and tting the headrests
Fig.98 Rear headrest: removal.
Removing the rear headrests
To remove the headrest, the corresponding
backrest must be partially folded forward.
●
Unlock the backrest ›››page125.
●
Move the headrest upwards to its highest po-
sition.
●
Press button ›››Fig.98
1
, while simultane-
ously pressing on the safety hole
2
with a at
screwdriver a maximum of 5 mm wide, and re-
move the headrest.
●
Move the backrest until it engages properly.
Fitting the rear headrests
To mount the external headrests, the corre-
sponding backrest must be partially folded for-
ward.

Related Topics

Popular Owner Manuals