2024-2026 Cupra Terramar SUV Visibility User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Visibility for Your Cupra Terramar SUV First Generation (2024-2026)

Visibility
139
Windscreen wiper and rear window wiper systems
/
Visibility
Windscreen wiper and
rear window wiper sys-
tems
Wiper lever
Fig.106 Operation of windscreen wipers
and rear window wiper system.
Move the button
A
to the required position:
Windscreen wipers o.
Intermittent wiping of the windscreen or
activates the rain sensor. The windshield
is wiped intermittently depending on the
speed of the vehicle or the heaviness of
the rain.
Slow wipe.
Fast wipe.
Button
1
:
Short press: activates a wiper sweep.
Long press: switches on windshield wash-
ers and wipers.
The Climatronic switches on air recircula-
tion for approx. 30 seconds to prevent the
smell of windscreen washer uid from en-
tering the vehicle interior.
With the ignition switched o, press
to set the wiper to its service position
›››
page338.
Button
2
:
Moving the button in the direction
of the arrow switches the automatic
rear window washer on. When the
button is released, it returns to the posi-
tion
.
WARNING
If insuicient antifreeze is added to the
washer uid, it could freeze on the glass and
impair visibility.
●
Do not use the wiper system in winter
temperatures without rst heating the wind-
screen with the heating and ventilation sys-
tem. Windscreen washer uid could freeze
on the windscreen and impair forward visibil-
ity.
WARNING
The use of worn or dirty wiper blades reduces
visibility and increases the risk of serious ac-
cidents and injuries.
●
Replace the wiper blades whenever they
are in poor condition or worn out and
no longer clean the windows suiciently
›››page339.
NOTICE
Before driving o and before switching on
the ignition, check the following aspects of
the wiper blades and the wiper motor to pre-
vent damage to the glass:
●
The wiper lever is in the neutral position.
●
You have removed or cleared any snow and
ice from the wiper blades and windows.
●
You have carefully removed any wiper
blades that may have frozen from the win-
dow. CUPRA recommends an de-icer spray
for this purpose.
NOTICE
Turn of the wiper before the glass is com-
pletely dry. Using the wipers while dry can
damage the glass.
140
Visibility
Note
●
When the vehicle stops while the wiper is
on, the wiper switches to operating tempora-
rily at the next lower wiping level.
●
In winter, the service position of the wipers
can be useful to make it easier to lift the wip-
ers o the windscreen when the vehicle is
going to be left stationary ›››
page339.
Wiper functions
Automatic rear window wiper
The rear wiper switches on automatically when
the wiper is switched on and reverse gear is en-
gaged. The automatic rear window wiper acti-
vation when engaging reverse gear can be acti-
vated and deactivated in the infotainment sys-
tem, in the vehicle settings menu ›››
page39.
Note
The windscreen will be wiped again approx-
imately 5 seconds after the windscreen
washer has been activated, provided the ve-
hicle is moving (“drip” function). If you acti-
vate the wipers less than 10 seconds after
the “drip” function, a new wash sequence will
begin without performing the last wipe. For
the “drip” function to work again, you have to
turn the ignition o and then on again.
Note
The wiper will try to wipe away any obstacles
that are on the windscreen. The wiper will
stop moving if the obstacle is still blocking its
path. Remove the obstacle and switch on the
wiper again.
Rain and light sensor
Fig.107 Sensitive surface of the rain
sensor.
The rain sensor controls the frequency of the
windscreen wiper intervals, depending on the
amount of rain ›››
.
Abnormal operation of the rain and light
sensor
The possible causes of anomalies and errone-
ous interpretations in the sensitive surface area
›››
Fig.107 of the rain sensor are, among oth-
ers:
●
Damaged wipers: a lm of water on the
damaged blades may lengthen the activation
time, reduce the washing intervals or result in a
fast and continuous wipe.
●
Insects: the impact of insects may cause the
wiper to activate.
●
Salt on the road: in winter, salt spread on
the roads may cause an excessively long wipe
when the windscreen is almost dry.
●
Dirt: dry dust, wax, coating on glass (Lotus
eect) or traces of detergent (car wash) may
reduce the eectiveness of the rain sensor or
make it react more slowly, later or not at all.
Regularly clean the sensitive surface of the rain
sensor ›››Fig.107 (arrow) and check for pos-
sible damage to the wiper blades.
●
Windscreen crack: the impact of a stone will
trigger a single wipe cycle with the rain sensor
on. The rain sensor then detects the reduction
of the sensor surface and adjusts itself. The
behaviour of the sensor may vary depending
on the size of the stone impact.
WARNING
The rain sensor may not detect rain sui-
ciently and may not activate the windscreen
wipers.
●
If necessary, switch on the windscreen wip-
ers manually when water hinders the view
through the windscreen.
Visibility
141
Mirrors
Note
●
The use of an alcohol-based glass cleaner
is recommended to remove waxes and coat-
ings.
●
Do not put stickers on the windscreen in
front of the rain sensor. This can cause alter-
ations or failures.
Troubleshooting
Windscreen washer uid level too low
The control lamp lights up in yellow. Rell the
washer uid reservoir at the next opportunity
›››
page360.
Mirrors
General safety instructions
The exterior and interior mirrors allow the
driver to observe vehicles driving behind and
adapt his or her driving behaviour accordingly.
For safe driving, it is important for the driver to
adjust the exterior mirrors and interior mirror
correctly before setting o.
When looking through the exterior mirrors and
the interior mirror, it is not possible to see the
entire area behind and to the sides of the vehi-
cle. These areas outside the eld of view are
known as the blind spot. Other road users and
objects may be in the blind spot.
WARNING
Adjusting the exterior mirrors and interior
mirror while driving can distract the driver.
This could cause accidents and lead to seri-
ous injuries
●
Only adjust the exterior mirrors and inte-
rior mirror when the vehicle is stationary.
●
When parking, changing lanes, overtaking
or turning, always keep a close eye on your
surroundings, as other road users or objects
may also be in the blind spot.
●
Always make sure that the mirrors are ad-
justed correctly and that visibility to the rear
is not reduced by ice, snow, fogging or other
objects.
WARNING
A failure to accurately estimate the distance
to vehicles driving behind can lead to serious
accidents and injuries.
●
Curved (convex or aspherical) mirrors in-
crease the eld of view and objects in them
appear smaller and further away.
●
Curved mirrors do not allow you to pre-
cisely calculate the distance to vehicles driv-
ing behind, so using them when changing
lanes could cause serious accidents and inju-
ries.
●
If possible, use the interior mirror to pre-
cisely calculate the distance to vehicles driv-
ing behind you, or to other objects.
●
Always make sure you have suicient visi-
bility to the rear.
WARNING
The automatic anti-dazzle mirrors contain an
electrolyte uid which could leak if the mir-
ror is broken.
●
If it gets out, the electrolyte uid can
irritate the skin, eyes and respiratory or-
gans, particularly in the case of people with
asthma or similar diseases. Immediately in-
hale enough fresh air and get out of the vehi-
cle, or open all windows and doors if this is
not possible.
●
If the electrolyte uid comes into contact
with your eyes or skin, immediately rinse the
aected area with plenty of water for at least
15 minutes and seek medical advice.
●
If the uid comes into contact with foot-
wear or clothing, rinse immediately with
plenty of water for at least 15 minutes. Clean
thoroughly before using the footwear or
clothing in question again.
●
If the electrolyte uid is swallowed, imme-
diately rinse the mouth with plenty of water
for at least 15 minutes. Do not induce vomit-
ing unless advised by a doctor. Immediately
seek medical attention.
142
Visibility
/
NOTICE
Electrolyte uid may leak if the automatic
anti-dazzle mirror is broken. This liquid at-
tacks plastic surfaces. Therefore, it should
be cleaned as fast as possible with a damp
sponge or similar.
Interior mirror
Interior mirror with automatic anti-dazzle
function
When the ignition is switched on, the sensors
in the mirror measure the light falling on it from
behind and in front.
The interior mirror automatically darkens
based on the measured values.
If the light falling onto the sensors is blocked or
interrupted, e.g. by a sunshade blind or hang-
ing objects, the automatic anti-dazzle interior
mirror does not work or does not work prop-
erly. Similarly, the use of portable navigation
devices attached to the windscreen or close to
the automatic anti-dazzle interior mirror can
aect the operation of the sensors ›››
.
The automatic anti-dazzle function is deacti-
vated in certain situations, e.g. when reverse
gear is engaged.
WARNING
Light from screens of portable navigation
devices can cause malfunctions of the au-
tomatic anti-dazzle interior mirror and may
cause serious accidents and injuries.
●
Abnormal operation of the automatic anti-
dazzle function may result in it being impos-
sible to use the interior mirror to precisely
calculate the distance to vehicles driving be-
hind, or to other objects.
Adjusting the exterior mirrors
Fig.108 Driver’s door detail: exterior
mirror control.
Turn the control to the corresponding posi-
tion.
By moving the control to the desired po-
sition, adjust the rear view mirrors on the
left side (
) and on the right side ( ) in the
desired direction.
Depending on the equipment tted on
the vehicle, the mirrors may be heated
according to the outside temperature.
Fold the mirrors ››› .
The exterior mirror cannot be adjusted
and all functions are deactivated.
Activating exterior mirror functions
The following exterior mirror functions can
be activated and deactivated in the vehicle
settings menu of the infotainment system
›››page39.
Note
The exterior mirror functions are described
below. For left-hand drive vehicles, position
corresponds to the exterior mirror on the
driver’s side and position corresponds to
the exterior mirror on the passenger’s side.
Do the opposite for right-hand drive vehi-
cles.
Visibility
143
Mirrors
1)
Do the opposite in right-hand drive vehicles.
2)
Not available in all markets.
Synchronized regulation of the exterior mir-
rors
The synchronised mirror setting simultane-
ously adjusts the right hand exterior mirror
when the left mirror is adjusted.
●
Turn the control to position
1)
.
●
Adjust the left-hand exterior mirror. The
right exterior mirror will be adjusted at the
same time (synchronised).
●
If necessary, correct the setting of the right
hand mirror: turn the control to position
1)
.
Folding the exterior mirrors when locking
the vehicle
When the vehicle is locked or unlocked from
the outside, the exterior mirrors may fold in
or out automatically, depending on the equip-
ment. For this purpose, the rotary control has
to be in position
, , , or .
If the rotary control of the electric exterior mir-
rors is in the folded position, the exterior mir-
rors remain folded.
Memory function
The memory buttons ›››page128 can be
used to save and turn on settings for the exte-
rior mirrors.
The settings will also be saved in the user of
the online services
2)
.
Saving the passenger rear view mirror set-
tings for reversing
●
Switch the ignition on.
●
In the infotainment system, select > Vehi-
cle > Exterior > Mirrors ›››page39.
●
Select position
1)
on the control.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb area
well.
●
Release the reverse gear.
●
The adjusted position for the rear view mirror
is stored.
Activating the passenger side exterior mirror
settings for reversing
●
Turn the exterior mirror control knob to posi-
tion
1)
.
●
Engage reverse gear with the ignition
switched on. The right-hand exterior rear-view
mirror will move to the saved position.
The passenger side exterior mirror leaves the
saved reversing position when the vehicle is
travelling faster than approx. 15km/h (9mph),
or if the control is turned from position
to
another position.
WARNING
Folding the exterior mirrors in and out care-
lessly can cause injury.
●
Only fold or unfold the exterior mirror if
there is no one in the path of the mirror.
●
When moving the mirror, be careful not to
pinch your ngers between the mirror and
the mirror holder.
NOTICE
●
Before washing the vehicle in an automatic
car wash, please make sure that the exterior
mirrors are folded in to prevent them from
being damaged.
●
The electrically folding exterior mirrors
must only be operated electrically, not by
hand, as this could damage their electric
drive.
144
Visibility
For the sake of the environment
Do not leave the exterior mirror heating on
for longer than necessary. Otherwise it cau-
ses unnecessary energy consumption.
Note
If the electrical adjustment should fail to op-
erate, both of the mirrors can be adjusted
by hand by lightly pressing the edge of the
mirror glass.
Sun protection
Sun blind
Fig.109 Sun visor
Options for adjusting driver and front pas-
senger sun visors
●
Lower the sun visor towards the windscreen.
●
The sun visor can be pulled out of its mount-
ing and turned towards the door ›››Fig.109
1
.
●
Swing the sun visor towards the door, longi-
tudinally backwards.
There is a vanity mirror on the sun visor, with
a cover. When the cover is opened
2
a light
comes on.
The light goes out when the vanity mirror cover
is closed or the sun visor is pushed back up.
WARNING
Folded sun blinds can reduce visibility.
●
Always store sun blinds and visors in their
housing when not in use.
Note
The light above the sun visor automatically
switches o after a few minutes in certain
conditions. This prevents the battery from
discharging.

Related Topics

Popular Owner Manuals