2024-2026 Cupra Terramar SUV Visibility -> Windscreen wiper and rear window wiper systems User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Visibility -> Windscreen wiper and rear window wiper systems for Your Cupra Terramar SUV First Generation (2024-2026)

Visibility
139
Windscreen wiper and rear window wiper systems
/
Visibility
Windscreen wiper and
rear window wiper sys-
tems
Wiper lever
Fig.106 Operation of windscreen wipers
and rear window wiper system.
Move the button
A
to the required position:
Windscreen wipers o.
Intermittent wiping of the windscreen or
activates the rain sensor. The windshield
is wiped intermittently depending on the
speed of the vehicle or the heaviness of
the rain.
Slow wipe.
Fast wipe.
Button
1
:
Short press: activates a wiper sweep.
Long press: switches on windshield wash-
ers and wipers.
The Climatronic switches on air recircula-
tion for approx. 30 seconds to prevent the
smell of windscreen washer uid from en-
tering the vehicle interior.
With the ignition switched o, press
to set the wiper to its service position
›››
page338.
Button
2
:
Moving the button in the direction
of the arrow switches the automatic
rear window washer on. When the
button is released, it returns to the posi-
tion
.
WARNING
If insuicient antifreeze is added to the
washer uid, it could freeze on the glass and
impair visibility.
●
Do not use the wiper system in winter
temperatures without rst heating the wind-
screen with the heating and ventilation sys-
tem. Windscreen washer uid could freeze
on the windscreen and impair forward visibil-
ity.
WARNING
The use of worn or dirty wiper blades reduces
visibility and increases the risk of serious ac-
cidents and injuries.
●
Replace the wiper blades whenever they
are in poor condition or worn out and
no longer clean the windows suiciently
›››page339.
NOTICE
Before driving o and before switching on
the ignition, check the following aspects of
the wiper blades and the wiper motor to pre-
vent damage to the glass:
●
The wiper lever is in the neutral position.
●
You have removed or cleared any snow and
ice from the wiper blades and windows.
●
You have carefully removed any wiper
blades that may have frozen from the win-
dow. CUPRA recommends an de-icer spray
for this purpose.
NOTICE
Turn of the wiper before the glass is com-
pletely dry. Using the wipers while dry can
damage the glass.
140
Visibility
Note
●
When the vehicle stops while the wiper is
on, the wiper switches to operating tempora-
rily at the next lower wiping level.
●
In winter, the service position of the wipers
can be useful to make it easier to lift the wip-
ers o the windscreen when the vehicle is
going to be left stationary ›››
page339.
Wiper functions
Automatic rear window wiper
The rear wiper switches on automatically when
the wiper is switched on and reverse gear is en-
gaged. The automatic rear window wiper acti-
vation when engaging reverse gear can be acti-
vated and deactivated in the infotainment sys-
tem, in the vehicle settings menu ›››
page39.
Note
The windscreen will be wiped again approx-
imately 5 seconds after the windscreen
washer has been activated, provided the ve-
hicle is moving (“drip” function). If you acti-
vate the wipers less than 10 seconds after
the “drip” function, a new wash sequence will
begin without performing the last wipe. For
the “drip” function to work again, you have to
turn the ignition o and then on again.
Note
The wiper will try to wipe away any obstacles
that are on the windscreen. The wiper will
stop moving if the obstacle is still blocking its
path. Remove the obstacle and switch on the
wiper again.
Rain and light sensor
Fig.107 Sensitive surface of the rain
sensor.
The rain sensor controls the frequency of the
windscreen wiper intervals, depending on the
amount of rain ›››
.
Abnormal operation of the rain and light
sensor
The possible causes of anomalies and errone-
ous interpretations in the sensitive surface area
›››
Fig.107 of the rain sensor are, among oth-
ers:
●
Damaged wipers: a lm of water on the
damaged blades may lengthen the activation
time, reduce the washing intervals or result in a
fast and continuous wipe.
●
Insects: the impact of insects may cause the
wiper to activate.
●
Salt on the road: in winter, salt spread on
the roads may cause an excessively long wipe
when the windscreen is almost dry.
●
Dirt: dry dust, wax, coating on glass (Lotus
eect) or traces of detergent (car wash) may
reduce the eectiveness of the rain sensor or
make it react more slowly, later or not at all.
Regularly clean the sensitive surface of the rain
sensor ›››Fig.107 (arrow) and check for pos-
sible damage to the wiper blades.
●
Windscreen crack: the impact of a stone will
trigger a single wipe cycle with the rain sensor
on. The rain sensor then detects the reduction
of the sensor surface and adjusts itself. The
behaviour of the sensor may vary depending
on the size of the stone impact.
WARNING
The rain sensor may not detect rain sui-
ciently and may not activate the windscreen
wipers.
●
If necessary, switch on the windscreen wip-
ers manually when water hinders the view
through the windscreen.

Related Topics

Popular Owner Manuals