Get Practical advice -> Headlights, lights: replacing bulbs Guide for Dacia Duster SUV Third Generation (2024-2026)

HEADLIGHTS, LIGHTS: REPLACING BULBS

Exterior lighting: replacing bulbs

Unclip the connector 2, remove the

assembly from its housing and take

out the bulb.

Front headlights: replacing the

bulbs

Bulb type: H7.

Before replacing the bulb, make a

careful note of its position in its hous-

ing. After changing it, check that the

replacement bulb is in exactly the

same position in the housing. Clip the

cover in place.

Dipped beam headlight 3 (LED)

(depending on the vehicle)

Consult an approved Dealer.

6

Remove the cover A .

Daytime running light/side light 4

(LED)

(depending on the vehicle)

Consult an approved Dealer.

Direction indicator light 5 (LED)

Main beam headlight 1

(depending on the vehicle)

Consult an approved Dealer.

(depending on the vehicle)

346 - Practical advice

HEADLIGHTS, LIGHTS: REPLACING BULBS

Release the connector 3 and unlock

the clips 4 to remove the bulb holder

5.

Please note when work-

ing close to the engine

that it may be hot. The

engine cooling fan may

also start at any moment. The

label in the engine com-

partment reminds you of this.

Risk of injury.

Rear lights: changing bulbs

6

Direction indicator lights / brake and

side lights

Unscrew the nut 1 and take out the

light unit 2 from the outside.

To comply with current leg-

islation, or as a precaution,

you can obtain an emer-

gency kit from your approved

dealer containing a set of spare

bulbs and fuses.

Open the luggage compartment lid and

remove the cover A .

Practical advice - 347

HEADLIGHTS, LIGHTS: REPLACING BULBS

Refitting

The bulbs are under

pressure and may break

when replaced.

Do not touch the ex-

haust.

Risk of burns.

To refit, proceed in the reverse order,

taking care not to damage the wiring.

Once the bulb has been replaced,

check that it is properly secured.

Risk of injury.

However, because of their reduced ac-

cessibility, we advise you to have

your bulbs replaced by an Approved

Dealer.

Refitting

To re-fit, proceed in the reverse order

taking care not to damage the wiring,

tighten nut 1 first.

6

6. Side light

Bulb type: W5W.

High-level brake light LED 10

7. Direction indicator lights

Bulb type: WY16W.

Reversing light 9

Consult an approved Dealer.

(depending on the vehicle)

8. Side light and brake light

Bulb type: P21/5W.

Access the bulb holder located under

the rear bumper, then unscrew it by

turning towards the centre of the vehi-

cle and remove the bulb.

Bulb type: P21W.

348 - Practical advice

HEADLIGHTS, LIGHTS: REPLACING BULBS

– turn the bulb holder by a quarter of a

turn;

Fog lights: changing bulbs

Front fog lights

– remove the bulb.

6

Number plate light 11 (LED)

(depending on the vehicle)

Consult an approved Dealer.

Replace the right-hand front fog

lights 3

Replace the left-hand front fog

lights 1

The bulbs are under

pressure and may break

when replaced.

Because of their reduced accessibility,

we advise you to have your bulbs

replaced by an approved Dealer.

(depending on the vehicle)

– Access the bulb holder by unclipping

the flap 2;

– turn the bulb holder by a quarter of a

turn;

Risk of injury.

(depending on the vehicle)

– Turn the steering wheel fully to the

left;

– remove the bulb.

– unscrew the wheel arch fasteners;

– turn the bulb holder by a quarter of a

turn;

or

– Unscrew the screw using a screw-

driver;

– access the bulb holder by unclipping

the flap 2;

– remove the bulb.

or

Practical advice - 349

HEADLIGHTS, LIGHTS: REPLACING BULBS

– Unscrew the screw using a screw-

driver;

– access the bulb holder by unclipping

the flap 4 ;

– turn the bulb holder by a quarter of a

turn;

turning towards the centre of the vehi-

cle and remove the bulb.

Please note when work-

ing close to the engine

that it may be hot. The

Bulb type: P21W.

engine cooling fan may

Do not touch the ex-

haust.

Risk of burns.

also start at any moment. The

– remove the bulb.

Bulb type: H16.

label in the engine com-

partment reminds you of this.

Risk of injury.

The bulbs are under

pressure and may break

when replaced.

Refitting

To refit, proceed in the reverse order,

taking care not to damage the wiring.

Rear fog light 5

Risk of injury.

Once the bulb has been replaced,

check that it is properly secured.

(depending on the vehicle)

6

However, because of their reduced ac-

cessibility, we advise you to have

your bulbs replaced by an approved

Dealer.

Refitting

To refit, proceed in the reverse order,

taking care not to damage the wiring.

Once the bulb has been replaced,

check that it is properly secured.

The bulbs are under

pressure and may break

when replaced.

However, we would advise you to

have these bulbs replaced by an Ap-

proved Dealer.

Risk of injury.

To comply with local legisla-

tion, or as a precaution, you

can obtain an emergency

kit containing a set of spare bulbs

and fuses from an approved deal-

er.

Access the bulb holder located under

the rear bumper, then unscrew it by

350 - Practical advice

HEADLIGHTS, LIGHTS: REPLACING BULBS

bulb replaced by an approved deal-

er.

Any operation on (or

modification to) the elec-

To access the bulb:

trical system must be

performed by an ap-

proved Dealer since an incorrect

connection might damage the

electrical equipment (harness,

components and in particular the

alternator). In addition, your Deal-

er has all the parts required for fit-

ting these units.

6

Indicator lights: changing bulbs

– unclip the shell 4 using a flat-blade

screwdriver or similar (movement B );

– carefully unclip the door mirror shell

2 from its base 3 (movement A );

As the door mirror shell needs to be

removed, we advise you to have the

Practical advice - 351

HEADLIGHTS, LIGHTS: REPLACING BULBS

– unscrew the screws 5 using a

screwdriver;

The bulbs are under

pressure and may break

when replaced.

Risk of injury.

Interior lighting: changing bulbs

Front ceiling light 1

6

– turn the lamp holder 7 and pull out

the bulb 8.

– unclip the cover 6 of the repeater 1

Bulb type: WY5W.

to access the lamp;

To refit it, carry out the above opera-

tions in reverse order.

Make sure:

– that the bulb holder 7 is aligned cor-

rectly before inserting it into its hous-

ing;

– that the door mirror shell 2 clips

properly onto its base 3.

– Unclip the lens 2 using a tool such

as a flat-head screwdriver positioned

at area A ;

When disassembling and refitting,

ensure that the wiring and the sur-

rounding components are not dam-

aged.

352 - Practical advice

HEADLIGHTS, LIGHTS: REPLACING BULBS

Bulb type 5 : W5W.

Refitting

Front reading spot lights 6

(depending on the vehicle)

– Clip the lens 2 onto the bulb holder

3 ;

6

– unclip and release the bulb holder 3

using the tabs 4;

– remove the bulb concerned.

– Unclip the lens 7 using a tool such

as a flat-head screwdriver positioned

at area B ;

– clip in the courtesy light 1 until your

hear the click;

– ensure that the courtesy light is

properly positioned and locked into

place.

The bulbs are under

pressure and may break

when replaced.

Risk of injury.

Practical advice - 353

HEADLIGHTS, LIGHTS: REPLACING BULBS

Bulb type 10 : W5W.

Refitting

– Clip the lens 7 onto the bulb holder

8 ;

6

– unclip and release the bulb holder 8

using the tabs 9;

– remove the bulb concerned.

– Unclip the lens 12 using a tool such

as a flat-head screwdriver positioned

at area C ;

– clip in the reading spot light unit 6

until it clicks;

– make sure that the reading spot

lights block is correctly positioned and

locked into place.

Rear reading spot light 11

(depending on the vehicle)

354 - Practical advice

HEADLIGHTS, LIGHTS: REPLACING BULBS

– unclip and release the bulb holder

13 using the tabs 14 ;

– remove the bulb concerned.

6

– clip in the reading spot light unit 11

until you hear the click;

– make sure that the reading spot

lights block is correctly positioned and

locked into place.

Unclip the light 16 using a flat-blade

screwdriver or similar tool, pressing on

the tab 17 to move the light towards

the inside of the glovebox.

Bulb type 15 : W5W.

Refitting

Disconnect the light.

Bulb type: W5W.

– Clip the lens 12 onto the bulb holder

13;

The bulbs are under

pressure and may break

when replaced.

Risk of injury.

Glovebox light 16

(depending on the vehicle)

Practical advice - 355

HEADLIGHTS, LIGHTS: REPLACING BULBS

Luggage compartment light 18

6

Release the lens 19 and access the

bulb 20 .

Unclip the light 18 by using a flat-

blade screwdriver or similar tool to

press on the tab 19 to move the light

towards the inside of the luggage com-

partment.

Bulb type 20 : W5W.

The bulbs are under

pressure and may break

when replaced.

Disconnect the light.

Risk of injury.

356 - Practical advice

Practical advice -> Headlights, lights: replacing bulbs for Your Dacia Duster SUV Third Generation (2024-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals