Get Access -> Alarm Guide for DS 7 Crossback 4 Door First Generation (2017-2022)

Access

of its electric motor, after which opening and

closing will not be possible.

Allow at least 10 minutes for the electric motor

to cool down before operating the tailgate

again.

– Or remove the electronic key from the

recognition zone, with the tailgate closed.

For more information on the Towing device

with retractable towball, refer to the

corresponding section.

The alarm is triggered if anyone tries to open a

door, the boot or the bonnet, for example.

Interior volumetric monitoring

The system checks for any variation in volume in

the passenger compartment.

The alarm is triggered if anyone breaks a window,

enters the passenger compartment or moves

inside the vehicle.

If you are unable to wait, operate it manually.

In wintry conditions

To avoid any operating problems, remove

the snow or wait until the ice melts before

requesting motorised opening of the tailgate.

Manual closing of the

motorised tailgate in case of

failure

This operation is only necessary in the case of

failure of the tailgate motor.

If the failure originates from the battery, it is

recommended to recharge it or change it with the

tailgate closed.

Anti-tilt monitoring

The system checks for any change in the attitude

of the vehicle.

The alarm goes off if the vehicle is lifted or moved.

When washing

When washing the vehicle in an automatic

car wash, do not forget to lock the vehicle to

prevent any risk of unwanted opening.

When the vehicle is parked, the alarm will

not be triggered if the vehicle is knocked.

Self-protection function

In this situation, a significant force may be

needed to close the tailgate.

►ꢀ Close it gently without slamming, as slowly as

possible, by pushing at the centre of the tailgate.

Alarm

(Depending on version)

The system checks for the putting out of service

of its components.

The alarm is triggered if the battery, the central

control or the siren wiring is put out of service or

damaged.

Do not lower the tailgate by pushing at

one of its sides - risk of damage!

For all work on the alarm system, contact

a dealer or a qualified workshop.

Precautions in use

To avoid unintentionally opening the

tailgate while operating the towing

device:

– Deactivate the “Hands-Free Tailgate

Access” function in advance in the vehicle

configuration menu.

Locking the vehicle with full

alarm system

System which protects and provides a deterrent

against theft and break-ins.

Activation

►ꢀ Switch off the ignition and exit the vehicle.

Exterior perimeter monitoring

The system checks for opening of the vehicle.

Access

►ꢀ Lock or deadlock the vehicle using the remote

control or with the “Keyless Entry and Starting”

system.

When the monitoring system is active, the red

indicator lamp in the button flashes once per

second and the direction indicators come on for

about 2 seconds.

The exterior perimeter monitoring is activated

after 5 seconds and the interior volumetric and

anti-tilt monitoring after 45 seconds.

Reactivating the interior volumetric and

anti-tilt monitoring

Locking the vehicle with

exterior perimeter monitoring

only

►ꢀ Deactivate the exterior perimeter monitoring

by unlocking the vehicle using the remote control

or the Keyless Entry and Starting system.

The indicator lamp in the button goes off.

►ꢀ Reactivate all monitoring by locking the

vehicle using the remote control or the Keyless

Entry and Starting system.

Disable volumetric monitoring to avoid unwanted

alarm triggering in certain cases, such as:

– Slightly open window.

– Washing the vehicle.

– Changing a wheel.

– Towing your vehicle.

– Transport on a ship or ferry.

The red indicator lamp in the button once again

flashes every second.

If an opening (door, boot or bonnet) is not

properly closed, the vehicle is not locked,

but the exterior perimeter monitoring will be

activated after 45 seconds, at the same time

as the interior volumetric and anti-tilt

monitoring.

Deactivating the interior volumetric and

anti-tilt monitoring

►ꢀ Switch off the ignition and within 10 seconds

press the alarm button until its red indicator lamp

is on fixed.

Triggering of the alarm

This is indicated by sounding of the siren and

flashing of the direction indicators for 30

seconds.

The monitoring functions remain active until

the alarm has been triggered eleven times in

succession.

When the vehicle is unlocked using the remote

control or the Keyless Entry and Starting system,

rapid flashing of the indicator lamp in the button

informs you that the alarm was triggered during

your absence. When the ignition is switched on,

the flashing stops immediately.

►ꢀ Get out of the vehicle.

Deactivation

►ꢀ Lock the vehicle immediately using the remote

control or with the “Keyless Entry and Starting”

system.

Only the exterior perimeter monitoring is

activated; the red indicator lamp in the button

flashes every second.

►ꢀ Press the remote control unlocking

button.

►ꢀ Unlock the vehicle with the "Keyless Entry and

Starting" system.

The monitoring system is deactivated: the

indicator lamp in the button goes off and the

direction indicators flash for about 2 seconds.

To take effect, this deactivation must be

carried out after each time the ignition is

switched off.

Failure of the remote control

To deactivate the monitoring functions:

►ꢀ Unlock the vehicle using the key in the driver's

door lock.

If the vehicle automatically locks itself

again (as happens if a door or the boot is

not opened within 30 seconds of unlocking),

the monitoring system is automatically

reactivated.

►ꢀ Open the door; the alarm is triggered.

Access

►ꢀ Switch on the ignition; this stops the alarm.

The indicator lamp in the button goes off.

Automatic operation

Electric windows

►ꢀ To open/close the window, press/pull the

switch past its resistance point: the window

opens/closes completely when the switch is

released.

Locking the vehicle without

activating the alarm

►ꢀ Lock or deadlock the vehicle using the key

(integral to the remote control) in the driver's door

lock.

Operating the switch again stops the movement

of the window.

Window controls remain operational for

approximately 45 seconds after switching

off the ignition or after locking the vehicle.

After that time, the controls are disabled.

To reactivate them, switch on the ignition or

unlock the vehicle.

Automatic activation

(Depending on version)

The system is activated automatically 2 minutes

after the last door or the boot is closed.

►ꢀ To avoid triggering the alarm on entering the

vehicle, first press the unlocking button on the

remote control or unlock the vehicle using the

“Keyless Entry and Starting” system.

1. Left-hand front.

2. Right-hand front.

3. Left-hand rear.

4. Right-hand rear.

5. Deactivation of the electric window controls

located at the rear seats.

Deactivation of the rear door opening controls

(electric child lock)*.

Anti-pinch

If the window meets an obstacle while rising, it

stops and immediately partially lowers again.

Malfunction

Deactivation of the rear

controls for the rear electric

windows

For children's safety, press switch 5 to

deactivate the rear electric windows

controls.

The indicator lamp for the button comes on,

accompanied by a message confirming activation.

With the ignition on, it remains lit, as long as the

child lock remains activated.

When the ignition is switched on, fixed

illumination of the red indicator lamp in the

button indicates a malfunction of the system.

Have it checked by a dealer or a qualified

workshop.

Manual operation

►ꢀ To open/close the window, press/pull the

switch without passing the point of resistance;

the window stops as soon as the switch is

released.

* Depending on version.

Access -> Alarm for Your DS 7 Crossback 4 Door First Generation (2017-2022)

Related Topics

Access

Popular Owner Manuals

Latest Owner Manuals