Get Access -> Panoramic sunroof Guide for DS 7 Crossback 4 Door First Generation (2017-2022)

Access

Use of the rear electric windows from the driver's

controls remains possible.

It is important to ensure that passengers use

the electric windows correctly.

Pay particular attention to children when

operating windows.

Be aware of passengers and/or other persons

present when closing windows using the key or

the "Keyless Entry and Starting" system.

The sunroof or blind can be operated when the

ignition is turned on (if the battery is charged

enough), with the engine running, in STOP mode

of Stop & Start, and up to 45 seconds after turning

off the ignition or after locking the vehicle.

For versions fitted with an electric child

lock, this control also deactivates the

interior rear door controls.

For more information on the Child lock, refer to

the corresponding section.

Precautions

Do not put your head or arms through the

sunroof when driving - risk of serious

injury!

Reinitialising the electric

windows

After reconnecting the battery, or in the event

of abnormal window movement, the anti-pinch

function must be reinitialised.

Panoramic sunroof

The panoramic sunroof consists of a movable

glass panel that slides over the roof and a blind

that can be opened independently. Opening the

sunroof automatically opens the blind.

Ensure that any luggage or accessories

carried on the roof bars does not interfere

with the movement of the sunroof.

Do not place heavy loads on the movable glass

panel of the sunroof.

►ꢀ To operate the panoramic sunroof or the blind,

use the buttons in the roof console.

The anti-pinch function is disabled during the

following sequence of operations.

For each window:

If the sunroof is wet, following a shower

or washing the vehicle, wait until it is

completely dry before opening.

Do not operate the sunroof if it is covered by

snow or ice - risk of damage!

►ꢀ Lower the window fully, then raise it; it will

rise in steps of a few centimetres each time the

control is pressed. Repeat the operation until the

window is fully closed.

►ꢀ Continue to pull the control upwards for at

least one second after the window reaches the

closed position.

Use only plastic scrapers to remove snow or

ice from the sunroof.

If an electric window meets an obstacle

during operation, the movement of the

window must be reversed. To do this, press the

relevant switch.

When the driver operates the passengers’

electric window switches, it is important to

ensure that nothing can prevent the window

from closing properly.

Check the condition of the sunroof seals

regularly (presence of dust or deposits,

dead leaves, etc.).

If using a car wash, check that the roof is

correctly closed in advance and keep the

tip of the high-pressure lance at least 30

centimetres from the seals.

A. Sunroof control

B. Sunroof blind control

Access

Never leave the vehicle with the sunroof

open.

Opening / Closing

stops or resumes movement depending on the

position of the sunroof.

►ꢀ To open the sunroof or the blind, use the part

of the button located towards the rear.

►ꢀ To close the sunroof or the blind, use the part

of the button located towards the front.

Operation

Reinitialisation

When opening the sunroof fully, the movable

glass moves to a partially open position, then

slides over the roof. All intermediate positions are

allowed.

Following reconnection of the battery or in the

event of a fault or jerky movement of the sunroof

or blind, reinitialisation is required.

Operation of buttons

►ꢀ Pressing a button beyond its point of

resistance directly opens or closes the sunroof

fully.

►ꢀ Pressing the button again stops the current

movement.

►ꢀ When holding a button (without going

beyond the point of resistance), the movement

of the sunroof or blind stops when this button is

released.

►ꢀ When the sunroof is closed: pressing once

without passing the point of resistance moves it

to a partially open position.

►ꢀ Check that nothing is interfering with the

sunroof or blind and that the seals are clean.

►ꢀ With the ignition on, fully close the sunroof

and blind.

►ꢀ Press and hold the front part of button A, until

the sunroof and blind move slightly, then hold for

a further 1 second before releasing.

►ꢀ Wait 2 seconds and then press and hold the

front part of button A. The blind and the sunroof

will open and close, one after the other. When

both are completely closed again, hold for a

further 2 seconds and release.

Depending on the speed of the vehicle, the

partially open position may vary to

improve the acoustics.

Before operating the sunroof or blind

control buttons, ensure that no object or

person might prevent the movement.

Be particularly aware of children when

operating the sunroof or blind.

If something is trapped when operating

the sunroof or blind, you should reverse the

movement of the sunroof or blind by pressing

the control in question.

►ꢀ When the sunroof is partially open: pressing

once without passing the point of resistance

opens or closes it fully.

If there is an operating fault, restart the

whole procedure.

The roof and windows, then the blind, can

be closed by holding down the door

The driver must ensure that passengers use

the sunroof and blind correctly.

locking control. The operation stops as soon as

the locking control is released.

Anti-pinch system

If the sunroof or blind encounters an obstacle

when closing, the movement is automatically

reversed.

The roof anti-pinch system is designed to be

effective at speeds of up to 75 mph (120 km/h).

Closing of the blind is limited by the

position of the sunroof: the blind cannot

go further than the front of the mobile glass.

During simultaneous movements of the

sunroof and blind, the blind automatically

Access -> Panoramic sunroof for Your DS 7 Crossback 4 Door First Generation (2017-2022)

Related Topics

Access

Popular Owner Manuals

Latest Owner Manuals