In the event of a breakdown -> Warning triangle for Your DS 7 Crossback 4 Door First Generation (2017-2022)

177  
08  
In the event of a breakdown  
For all versions other than BlueHDi, the  
Assembling and placing the  
triangle  
Warning triangle  
components are located in the engine  
compartment; they can be found under the  
removable cover.  
As a safety precaution, before leaving your  
vehicle to set up and install the triangle, switch  
on the hazard warning lamps and put on your high  
visibility vest.  
For more information about the Engine  
compartment, in particular the location of  
these components under the bonnet, refer to  
the corresponding section.  
Storage compartment  
BlueHDi engines  
►ꢀ Switch on the ignition (without starting the  
engine).  
►ꢀ Wait around 1 minute and switch off the  
ignition.  
►ꢀ Operate the starter motor to start the engine.  
If the engine does not start at the first attempt,  
do not keep trying, but restart the procedure.  
For versions supplied with a triangle as original  
equipment, refer to the illustration above.  
For other versions, refer to the assembly  
instructions provided with the triangle.  
►ꢀ Put the triangle in place behind the vehicle, as  
required by local legislation.  
Non-BlueHDi engines  
►ꢀ Open the bonnet and then, if necessary, unclip  
the cover to access the priming pump.  
►ꢀ Loosen the degassing bolt.  
There is a compartment in the interior trim of the  
tailgate to store a warning triangle.  
►ꢀ After opening the tailgate, release the cover by  
turning the screw a quarter turn to the left.  
Running out of fuel  
(Diesel)  
►ꢀ Operate the priming pump until fuel  
appears in the transparent tube.  
►ꢀ Retighten the degassing bolt.  
►ꢀ Operate the starter motor until the engine  
starts (if the engine does not start at the first  
attempt, wait around 15 seconds before trying  
again).  
With Diesel engines, the fuel system must be  
primed if you run out of fuel.  
Before priming, at least 5 litres of Diesel fuel must  
be added to the tank.  
►ꢀ If the engine does not start after a few  
attempts, operate the priming pump again, then  
the starter motor.  
For more information on Refuelling and  
Misfuel prevention (Diesel), refer to the  
corresponding section.