13) Make sure that the backrests are
correctly secured on both sides ("red
marks" not visible) to prevent it from
moving forward in the event of sharp
braking, causing injuries to occupants.
You can select two heating levels:
❒ "minimum heating": (one orange LED
lit on the buttons);
❒ "maximum heating": two orange
LEDs lit on the buttons.
After selecting one heating level, you
need to wait for a few minutes until
warm air flows into the compartment.
When the "maximum heating" setting is
selected, the heater produces a
boosted heat level for the first minutes
of operation.
WARNING
4) The fabric upholstery for the seats has
been designed to withstand long-term
wear deriving from normal use of the
vehicle. Nevertheless, some precautions
are required. Avoid prolonged and/or
excessive rubbing involving clothing
accessories such as metal buckles,
bosses, Velcro strips and the like, which,
by applying a high pressure on the fabric in
a limited area, could cause it to break,
thereby damaging the upholstery.
F1B0027C
17
Repositioning the backrests
Move the seat belts to the side, making
sure that they are correctly extended
and not twisted.
IMPORTANT To preserve the battery
charge, this function cannot be
activated when the engine is off.
Raise the backrests and push them
back until the locking click of both
retainers is heard. Visually check that
the red marks have disappeared from
the release devices A fig. 17. The
red marks indicate that the backrest is
not secured.
REAR SEATS
5) Do not arrange objects beneath the
electrically adjustable seat and do not
impede its movement, since the controls
may be damaged. The fabric upholstery of
the seats has been designed to withstand
long-term wear deriving from normal use of
the vehicle. Nevertheless, some
precautions are required. Avoid prolonged
and/or excessive rubbing involving clothing
accessories such as metal buckles,
Partial extension of the boot (1/3 or
2/3)
13)
6)
❒ remove the rear shelf;
❒ completely lower the rear seat head
restraints;
WARNING
bosses, Velcro strips and the like, which,
by applying a high pressure on the fabric in
a limited area, could cause it to break,
thereby damaging the upholstery. They
may also restrict the seat travel.
❒ move the seat belt to the side,
making sure that it is fully extended and
not twisted;
11) Any adjustment must be performed
with the vehicle at a standstill.
12) After releasing the adjustment lever,
always check that the seat is locked on the
guides by trying to move it back and forth.
If the seat is not locked into place, it may
unexpectedly slide and cause the driver to
lose control of the vehicle.
❒ operate release device A fig. 17 to
fold the required backrest section. After
release a red mark is visible.
6) Before tilting the backrest, remove any
objects lying on the seat.
Accompany the backrest during folding.
17
English 