Advertisement

Advertisement

STARTING AND DRIVING -> LANE ASSIST SYSTEM (LANE CROSSING WARNING) for Your Fiat 500 X 4 Door First Generation (2014-2024)

If the vehicle continues going beyond  
the line of the lane without any  
intervention from the driver, the  
warning light (or the icon on the  
display) will be displayed on the  
instrument panel to urge the driver to  
bring the vehicle back into the limits of  
the lane.  
LANE ASSIST  
SYSTEM (lane  
crossing warning)  
DESCRIPTION  
44) 45) 46) 47) 48) 49)  
The Lane Assist system makes use of a  
camera located on the windscreen to  
detect the lane limits and calculate  
the position of the vehicle within such  
limits, in order to make sure that it  
remains inside the lane.  
IMPORTANT The system monitors the  
presence of the driver's hands on  
the steering wheel. If they are  
F1B0334C  
101  
On some versions, a dedicated  
message appears on the display when  
it is activated and deactivated.  
not detected, the system emits an  
acoustic signal and deactivates until it is  
reactivated by pressing the dedicated  
button (see description below).  
When one limit of the lane is detected  
and the vehicle crosses it (direction  
indicator off), warning light (or the  
icon on the display) will be displayed on  
the instrument panel to urge the driver  
to bring the vehicle back into the lane.  
In this case, the tactile warning  
(vibration on the steering wheel) is not  
provided.  
When both limits of the lane are  
detected and the vehicle crosses one of  
them without the awareness of the  
driver (direction indicator off), the Lane  
Assist system provides a tactile warning  
by applying torque to the steering  
wheel (vibration), thus advising the  
driver that he must take an action to  
remain in the lane.  
Activation conditions  
Once switched on, the system  
becomes active only if the following  
conditions are met:  
the driver always keeps at least one  
hand on the steering wheel;  
vehicle speed ranges between 60  
km/h and 180 km/h;  
IMPORTANT The torque applied to the  
steering wheel by the system is  
the lane limit lines are perfectly visible  
on both sides;  
SYSTEM ACTIVATION/  
DEACTIVATION  
sufficient for the driver to notice it, but  
always limited, so that they can easily  
override it, and the driver always  
maintains control of the vehicle. The  
driver can therefore turn the steering  
wheel as required at all times.  
there are suitable visibility conditions;  
The Lane Assist system can be  
enabled/disabled using button A fig.  
101, located on the left stalk.  
Each time the engine is started, the  
system keeps the activation status  
there was when it was previously  
switched off.  
the road is straight or with wide  
radius bends;  
a suitable distance is kept from the  
vehicle in front;  
the direction indicator (for leaving the  
lane) is not active;  
123  
48) The camera may have limited or absent  
operation due to weather conditions such  
as: heavy rain, hail, thick fog, heavy snow,  
formation of ice layers on the windscreen.  
the lane limit lines are perfectly visible  
on both sides (for activation of the  
tactile warning only).  
REAR VIEW CAMERA  
DESCRIPTION  
NOTE The system does not apply the  
vibration to the steering wheel every  
time a safety system is activated  
(brakes, ABS, ASR system, ESC  
system, Full Brake Control system,  
etc.).  
49) Camera operation may also be  
compromised by the presence of dust,  
condensation, dirt or ice on the  
windscreen, by traffic conditions (e.g.  
vehicles that are driving not aligned with  
yours, vehicle driving in a transverse or  
opposite way on the same lane, bend with  
a small radius of curvature), by road  
surface conditions and by driving  
The camera A fig. 102 is located on the  
tailgate.  
122)  
50)  
conditions (e.g. off-road driving). Make sure  
the windscreen is always clean. Use  
specific detergents and clean cloths to  
avoid scratching the windscreen. The  
camera operation may also be limited or  
absent in some driving, traffic and road  
surface conditions.  
WARNING  
44) Projecting loads on the roof of the  
vehicle may interfere with the correct  
operation of the camera. Before starting  
make sure the load is correctly positioned,  
in order not to cover the camera operating  
range.  
45) If the windscreen must be replaced  
due to scratches, chipping or breakage,  
contact exclusively a Fiat Dealership.  
Do not replace the windscreen on your  
own, risk of malfunction! It is advisable to  
replace the windscreen if it is damaged  
in the area of the camera.  
F1B0064C  
102  
Every time reverse is engaged, the  
display fig. 103 shows the area around  
the vehicle, as seen by the rear camera.  
46) Do not tamper with nor operate on the  
camera. Do not close the openings in  
the aesthetic cover located under  
the interior rear view mirror. In the event of  
a failure of the camera, contact a Fiat  
Dealership.  
47) Do not cover the operating range of the  
camera with stickers or other objects.  
Also pay attention to other objects on the  
bonnet (e.g. a layer of snow) and make  
sure they do not interfere with the camera.  
F1B0167C  
103  
124