Advertisement

Advertisement

STARTING AND DRIVING -> MOOD SELECTOR (DRIVING MODE SELECTOR) for Your Fiat 500 X 4 Door First Generation (2014-2024)

"Auto" MODE  
MOOD SELECTOR  
(driving mode  
selector)  
This mode is aimed at comfort and  
safety in normal grip and driving  
conditions. On 4x4 versions, this mode  
also reduces fuel consumption, since  
it automatically disconnects the  
transmission from the rear wheels if the  
road and driving conditions allow it, in  
addition to changing drive torque  
distribution between the front and rear  
axles.  
The Mood Selector is a device that  
allows the driver to select three different  
driving modes (vehicle response)  
according to their needs and to the  
road and traffic conditions, by manually  
adjusting the central tunnel knob ring  
nut A fig. 99.  
F1B0044C  
99  
The device, through the on-board  
electronic system, operates on the  
vehicle's dynamic control systems:  
engine, steering, ESC system, 4x4  
system (if available), gearbox/  
Activation  
Starting from the active "Traction/All  
Weather" mode, turn the ring nut  
anticlockwise, keeping it in this position  
for at least half a second, and in any  
case until the relevant LED turns on,  
and the selected mode is shown on the  
display. The LED for the previously set  
mode will simultaneously turn off. Upon  
release, the ring nut will return to the  
central position.  
- "Auto" mode  
transmission, and is interfaced with the  
instrument panel.  
The rotating ring nut is monostable  
type. In other words, it always returns  
to the central position when released.  
The acceptance by the system of  
the requested driving mode is signalled  
by the LED, located besides the  
symbol, coming on, and by the  
corresponding symbol appearing on the  
instrument panel display.  
- "Traction" mode (4x4 or 4x2 versions  
depending on the trim level)  
Starting from the active "Sport" mode,  
turn the ring nut clockwise, keeping it in  
this position for at least half a second,  
and in any case until the relevant LED  
turns on, and the selected mode is  
shown on the display. The LED for the  
previously set mode will simultaneously  
turn off. Upon release, the ring nut will  
return to the central position.  
- "All Weather" mode (only 4x2 versions  
depending on the trim level)  
When the engine is started the system  
normally stays in the driving mode  
that was active before switching off; for  
versions/markets where provided the  
system always sets itself to "Auto"  
mode at start-up.  
- "Sport" mode.  
119  
"Traction"/"All Weather" MODE  
"Sport" MODE  
FAULT INDICATIONS  
It is a driving mode for safety in poor  
vehicle grip conditions (wet/slippery  
road surface, rain, snow). On the 4x4  
versions use is also recommended  
on unsurfaced roads or off-road.  
It is the mode that emphasises the  
pleasure of sport driving; it increases  
fuel consumption however. Traction  
is optimised on 4x4 versions, allowing  
the vehicle road-hold performance  
to be improved, even on bends.  
In the case of system and selector  
faults, the mode change option will be  
automatically disabled. The system  
will automatically set itself to "Auto"  
mode. In these cases the display will  
show a dedicated warning. Go to a Fiat  
Dealership as soon as possible to  
have the system checked.  
Activation  
Activation  
Starting from the active "Auto" mode,  
turn the ring nut clockwise, keeping it in  
this position for at least half a second,  
and in any case until the relevant LED  
turns on, and the selected mode is  
shown on the display. The LED for the  
previously set mode will simultaneously  
turn off. Upon release, the ring nut will  
return to the central position.  
Starting from the active "Auto" mode,  
turn the ring nut anticlockwise, keeping  
it in this position for at least half a  
second, and in any case until the  
relevant LED turns on, and the selected  
mode is shown on the display. The  
LED for the previously set mode will  
simultaneously turn off. Upon release,  
the ring nut will return to the central  
position.  
Starting from the active "Sport" mode,  
turn the ring nut anticlockwise, keeping  
it in this position for at least half a  
second, and in any case until the  
relevant LED turns on, and the selected  
mode is shown on the display. The  
LED for the previously set mode will  
simultaneously turn off. Upon release,  
the ring nut will return to the central  
position.  
Starting from the active "Traction/All  
Weather" mode, turn the ring nut  
clockwise, keeping it in this position for  
at least half a second, and in any case  
until the relevant LED turns on, and  
the selected mode is shown on the  
display. The LED for the previously set  
mode will simultaneously turn off. Upon  
release, the ring nut will return to the  
central position.  
120