put the cable on the public charging
station;
NOTE To restore correct operation of
the system, contact the Fiat Dealership.
charging speed is necessary to preserve
the battery.
replace the protective cover of the
charging port;
close the charging flap, making sure
it locks properly.
CHARGING CABLE
EMERGENCY
UNLOCK
(for versions/markets, where provided)
If the charging cable does not unlock at
the end of the charging procedure, you
can unlock it manually.
WARNING
76) Using "Fast Charge - Mode 4" can
accelerate the battery degradation
process.
77) If fast charging is not required,
standard (AC) charging is always
preferred. This maximises battery life by
ensuring the best performance of the car
over time.
78) The charging times in "Fast Charge -
Mode 4" are referred to up to 80% of the
state of charge of the high-voltage battery
in standard environmental conditions
(25°C).
79) Charging times in extreme weather
conditions can increase by as much as
several minutes due to the intervention
of the high-voltage battery management
system, which ensures optimal regulation
of the battery temperature to prevent
possible damage.
80) The charging speed slows down when
the state of charge of the high-voltage
battery exceeds 80%.
81) The battery charging time can increase
by a few minutes in case of very cold/hot
outside temperatures, many quick
charging sessions, high frequency of use
of "Fast Charge - Mode 4" charging or
ageing of the battery. This reduction in
214
F0S1208
If, after closing and opening the doors
by pressing the relevant buttons
CHARGING
FUNCTIONS
/
located on the key and after
having pressed the button near the
charging port, it is still not possible to
remove the charge cable from the
socket on the car, it is possible to
act manually by operating a special
emergency unlocking device located
on the right side of the boot and
performing the operations described
below:
CHARGING SCHEDULE
Two charging modes are available:
immediate and scheduled.
The two charging modes can be
selected in two ways:
via the dedicated smartphone app
(refer to the chapter "Connected
Services - Uconnect Services" in the
"Multimedia" section) (where provided)
by means of the Uconnect™
system.
acting inside the boot, remove the
cap (A) fig. 214;
pull the release cord (B) fig. 214
(where provided) to manually unlock
the actuator of the charging port;
disconnect the charging cable;
check that the release cord (where
provided) is correctly repositioned
inside its housing, then reinsert the cap
(A) fig. 214.
The page available on the Uconnect™
system can be used to set charging
times when the car will be charged
via Mode 2 or Mode 3. By acting on
the Uconnect™ system display and
selecting the "Charging schedule"
function on the screen under the
206
English 