STARTING AND DRIVING -> PARKVIEW? REAR BACK UP CAMERA for Your Fiat 500 SUV Second Generation (2020-2025)

®
Sign Recognition" system has been  
acquired as the new Speed Limiter  
value, the activation of Intelligent Speed  
panel display (see what is described in  
the "Display" section in the "Getting to  
know your instrument panel" section);  
select the "Off" option to deactivate  
the system.  
PARKVIEW REAR  
BACK UP CAMERA  
(where provided)  
Assist is indicated by the symbol  
on the display and the relevant road  
sign is shown surrounded by green.  
DESCRIPTION  
On some versions the system will be  
automatically reactivated when the  
motor is next restarted.  
173)  
SYSTEM DEACTIVATION  
The system is deactivated under the  
following conditions:  
52)  
The camera is located on the boot  
tailgate fig. 181.  
EXCEEDING THE  
PROGRAMMED SPEED  
By fully depressing the accelerator  
pedal, the programmed speed can  
be exceeded even with the "Intelligent  
Speed Assist" system active (e.g. in  
the event of overtaking). The system is  
disabled until the speed drops below  
the set limit, after which it activates  
again automatically.  
when the Traffic Sign Recognition  
system is deactivated;  
when the Speed Limiter system is  
deactivated;  
when the Traffic Sign Recognition  
system shows a new speed limit which  
is not confirmed by the driver;  
when the Traffic Sign Recognition  
system shows the end of the speed  
limit;  
181  
F0S1441  
when the Traffic Sign Recognition  
system cannot display any speed limit.  
Camera activation/deactivation  
Every time reverse is engaged, the  
display fig. 182 shows the area around  
the car, as seen by the rear camera.  
Manual deactivation of the system  
by the driver  
Proceed as follows to deactivate the  
system (and remove the acoustic  
warning provided by the system when  
any road sign is detected):  
press the "Vehicle" graphic button on  
the proceed as Uconnect™ system  
display to access the "Settings"  
menu (see what is described in the  
Uconnect™ section) or select the  
"Settings" menu on the instrument  
176  
SYMBOLS AND  
MESSAGES ON THE  
DISPLAY  
Messages on the display  
If the tailgate is raised, the camera will  
not detect any obstacle in the area  
behind the car. A dedicated warning  
message will appear on the display.  
Closing the door will restore proper  
camera operation and the warning  
message on the display will disappear.  
Indications on the display  
Guideline display can be activated  
by acting on the settings of the  
Uconnect™ system (see "Settings" in  
the"Vehicle mode" paragraph in the  
"Multimedia" section).  
WARNINGS  
If activated, the grid is positioned on  
the image to highlight the width of the  
car and the expected reversing path  
in accordance with the steering wheel  
position.  
182  
F0S1274  
WARNING In some circumstances,  
such as with ice, snow or mud on the  
surface of the camera, the camera  
sensitivity may be reduced.  
The images are shown on the display  
together with a warning message.  
After shifting from position R (Reverse)  
to position D or N, the camera image  
will continue to be displayed for 10  
seconds if the dedicated function in the  
Uconnect™ system settings is active  
(see "Settings" in the"Vehicle mode"  
paragraph in the "Multimedia" section).  
The image will cease to be displayed  
before 10 seconds have elapsed if any  
of the following conditions occur:  
car speed is higher than 13 km/h;  
transmission in the P (Park) position;  
ignition device in the STOP position;  
press the graphic button on the  
Uconnect™ system display, which is  
shown on the camera image whenever  
the transmission is not in reverse  
position.  
A superimposed central broken line  
indicates the centre of the car to  
facilitate parking manoeuvres. The  
various coloured areas indicate the  
distance from the rear of the car.  
The table below shows the  
approximate distances for each area  
fig. 182:  
WARNING In some special  
circumstances (e.g. after long periods  
of inactivity or after disconnecting  
and reconnecting the battery), when  
activating the rear camera during  
Uconnect™ system initialisation, the  
guidelines and warning messages may  
not be displayed correctly; at the end  
of this phase, they will be automatically  
restored.  
Distance from  
the rear of the  
car  
Area  
WARNING If the tailgate is to be re-  
painted following to repairs, make sure  
the paint does not get in contact with  
the camera.  
Red (A)  
Yellow (B)  
Green (C)  
0 - 30 cm  
30 cm - 1 m  
1 m or more  
WARNING When parking, take the  
utmost care over obstacles that may  
NOTE The displayed image may look a  
bit distorted.  
177