Knowing Your Car -> Wiper Control Stalk for Your Fiat 600 SUV Second Generation (2023-2026)

They will switch off automatically after  
a delay. This function works only in the  
dark.  
NOTE In position 1 or 2, the wiping  
frequency is automatically reduced  
when the speed of the vehicle drops  
below 5 km/h (3 mph). When the speed  
is above 10 km/h (6 mph) again, the  
wiping frequency returns to the original  
frequency (fast or normal).  
WIPER CONTROL  
STALK  
12) 13) 14) 15)  
Vehicle locator lighting  
NOTE After using an automatic car  
wash, you may temporarily notice  
abnormal noises and poorer wiping  
performance. You do not need to  
replace the wiper blades.  
This function allows to locate the  
vehicle, e.g., in weak lighting conditions  
using the remote control. The  
headlights come on and the turn lights  
flash for 10 seconds.  
Single wipe  
Press and release the control stalk or  
briefly pull the control stalk towards  
you.  
Press on the remote control.  
Peripheral lighting  
WINDSCREEN WASH  
Pull the wiper control stalk towards  
you and hold. A final wiping cycle is  
performed when screenwashing ends.  
NOTE With automatic air conditioning,  
any action on the screenwash control  
results in temporary closure of the  
air intake to protect the passenger  
compartment from any odour.  
16)  
Peripheral lighting allows you to switch  
on the position lights, low beam and  
number plate lighting using the remote  
control.  
Press on the remote control to  
switch on peripheral lighting.  
73  
F6S0044  
Press a second time to switch off  
peripheral lighting.  
(1) Automatic wipers  
(2) Intermittent wipers  
Conventional battery discharge  
protection  
WINDSCREEN WIPERS  
To select the wiping speed: raise or  
lower the stalk fig. 73 to the desired  
position.  
FRONT INTERMITTENT  
WIPING  
To prevent discharge of the vehicle  
conventional battery when the ignition  
is switched off, some interior lights are  
switched off automatically after some  
time.  
In Intermittent mode, the driver can  
adjust the wiping frequency by turning  
the ring (2) fig. 74 to one of the 5  
available positions.  
2: Fast wiping (heavy rain)  
1: Normal wiping (moderate rain)  
Int: Intermittent wipers  
Auto: Automatic wipers  
0: Switching off  
x1: Manual  
47  
of precipitation depending on the  
sensitivity of the sensor selected.  
The rainfall detection function uses a  
rain/ sunshine sensor located at the top  
centre of the windscreen, behind the  
rear view mirror.  
system (Settings>Vehicle>Safety),  
fig. 75.  
NOTE In certain weather conditions  
(e.g. fog, frost, snow, projections on  
salty roads), the driver may have to  
return to manual wiping.  
74  
F6S0045  
Switching on/off  
The first (upper) position corresponds  
to the longest time interval between 2  
wipes for light rain.  
75  
F6S0171  
54)  
17) 18)  
Adjusting the sensitivity  
To switch on:  
The last (lower) position corresponds  
to the shortest time interval between 2  
wipes for heavy rain.  
Put the wiper control stalk in the  
AUTO position  
Turn the ring (3) fig. 76 to adjust  
the sensitivity of the sensor. A wiping  
cycle, accompanied by the display of a  
message, confirms that the request has  
been taken into account  
To switch off, put the wiper control  
stalk in another position or in the 0  
position  
A rotation of the ring from a higher  
position to a lower position triggers a  
confirmation wiping.  
After the ignition has been switched off  
for more than 1 minute with the wiper  
control stalk in the INT, 1 or 2 position,  
when the ignition is switched on again:  
the system works as soon as the  
vehicle exceeds 10 km/h (6 mph), if the  
outside temperature is below +3°C.  
the system works immediately, if the  
outside temperature is above +3°C.  
76  
F6S0045  
Windscreen wipers in reverse  
To increase safety during the  
The first position (upper) corresponds  
to the lowest sensitivity of the sensor.  
The last position (lower) corresponds to  
the highest sensitivity of the sensor.  
The higher the sensitivity, the faster the  
system reacts and increases the wiping  
frequency.  
manoeuvers in reverse gear, the  
rear window windscreen wiper  
can be automatically activated in  
case of rain. The function can be  
activated/deactivated through the  
Uconnect™ 10.25"/10.25" NAV  
AUTOMATIC  
WINDSCREEN WIPERS  
In AUTO mode, the front wipers work  
automatically and adapt to the intensity  
48