Emergency braking
HAZARD WARNING
LIGHTS
REPLACING A BULB
(for versions/markets, where provided)
In the event of emergency braking
the hazard warning lights come on
automatically, as do the and
GENERAL
INSTRUCTIONS
They are turned on by pressing switch
A fig. 152, regardless of the position
of the ignition key. Warning lights
and are lit up in the instrument
panel when this device is activated.
Press switch A again to turn the lights
off.
Before replacing a bulb check the
contacts for oxidation;
warning lights in the panel.
The function switches off automatically
when the nature of the braking
burnt bulbs must be replaced by
others of the same type and power;
always check the headlight beam
alignment after replacing a bulb;
changes. This function complies with
the relevant legislation currently in force.
IMPORTANT The use of hazard warning
lights is governed by the highway
code of the country you are in. Comply
with legal requirements.
when a light is not working, check
that the corresponding fuse is intact
before changing a bulb. For the location
of fuses, refer to the paragraph “If a
fuse blows” in this section.
120) 121)
24) 25)
IMPORTANT The headlight inner
surface might be slightly misted: this
does not indicate a fault, it is a natural
phenomenon due to low temperature
and the air humidity level. Misting
will disappear rapidly when the
headlights are turned on. The presence
of drops inside the headlights indicates
infiltration of water. Contact a Fiat
Dealership.
F0V0513
152
144
English 