Get Knowing Your Vehicle -> Boot Guide for Fiat Fiorino SUV Third Generation (2015-2026)

an area mid-way between both axles;

- lastly, remember that the dynamic

behaviour of the vehicle is affected by

the transported weight: in particular,

the stopping distances are longer,

especially at high speed.

ANCHORING YOUR LOAD

Hooks (various number, according to

version) are fixed to the floor for easy

securing load.

BOOT

OPENING THE TAILGATE

FROM THE OUTSIDE

(Qubo version)

Cargo versions fig. 67;

26) 27) 28) 29)

WARNING

26) Bumpy roads and abrupt braking

may cause unexpected load shifting with

consequently hazardous situations for the

driver and passengers: before setting off,

secure the load tightly using the partition

and appropriate hooks, steel cables, ropes

or chains strong enough to hold the items

to be secured.

69

F0T0250

67

F0T0057

Combi versions fig. 68.

27) Even when the car is stopped on a

steep hill or side slope, opening the rear or

side doors could cause unsecured goods

to fall out.

28) If you wish to carry a reserve of petrol

in a can, observe the legal restrictions and

only use a can that is type-approved and

properly secured to the load anchoring

eyebolts. In the event of a collision the fire

risk is increased all the same.

70

F0T0381

68

F0T0058

29) Each of these must be strictly

observed and MUST NEVER BE

The tailgate (when unlocked) can only

be opened from the outside of the car

using the electric opening handle (A)

fig. 69 located under the handle.

The tailgate can be opened at any time

if the doors are unlocked.

EXCEEDED in any case. In particular,

ensure that you never exceed the

maximum permitted weights on the front

and rear axles when arranging the load

on the vehicle (particularly if the vehicle is

equipped with a specific trim level).

LOADING ADVICE

Some simple suggestions can improve

driving safety, comfort and vehicle

duration: - distribute the load evenly

over the platform: if it must be

To open it, enable the handle, opening

one of the front doors or unlocking the

concentrated it in a single area, choose

45

doors with the remote control or using

the key without remote control.

The tailgate unlocks also by pressing

open the sliding side door and lower

the backrest of the rear seat to gain

access to the boot (Combi versions);

or

the button

on the remote control.

To close the tailgate use handle (B)

fig. 70.

30)

EMERGENCY OPENING

FROM THE INSIDE

(Qubo version)

73

F0T0139

To open them wider to an angle of 180

degrees, push the locking device (A)

fig. 74 (one on each side) as shown in

the diagram and simultaneously open

the doors.

72

F0T0060

open the sliding side door (Cargo

versions);

33) 34)

use device (A) fig. 72 located on the

inside of the right-hand swing door;

open the left-hand swing door by

pulling the handle (see "Doors" in this

section).

71

F0T0285

In the event of an emergency, you can

open the tailgate from inside as follows:

Open the sliding side door and fully

fold the rear seats;

31) 32)

DOUBLE REAR WING

DOORS

(for versions/markets, where provided)

The double rear swing doors fig. 73 are

fitted with a spring-loaded system that

stops them when they have opened to

an angle of approximately 90 degrees.

from inside the boot, press lever (A)

fig. 71 and open the tailgate.

31) 32)

74

F0T0375

EMERGENCY OPENING

FROM THE INSIDE

(Fiorino version)

In the event of an emergency, you can

open the tailgate from inside as follows:

46

back of the front seats and the folded

rear seat.

Opening/closing the first swing

door from the outside

After having opened the first door, pull

handle (A) fig. 76 in the direction shown

by the arrow.

WARNING Pull handle (A) fig. 76 in the

direction of the arrow only.

REMOVING THE PARCEL

SHELF

(Fiorino Combi and Qubo versions)

The parcel shelf fig. 77consists of

two parts. To remove it completely,

proceed as follows:

open the rear swing doors; lift the

front part (A) fig. 77 releasing the pin (A)

fig. 78 from the housing (F) fig. 78;

75

F0T0140

78

F0T0456

To open the door, turn the metallic

insert of the key in the lock or press

button

and then pull handle (A) fig. 75 in the

direction of the arrow.

To close the door, turn the key in the

lock or press button on the remote

control.

To refit the parcel shelf, follow the same

procedure in reverse.

on the remote control

35)

EXTENDING THE BOOT

34)

Opening the second swing door

77

F0T0062

79

F0T0921

lift the rear part (B) fig. 77 releasing

the pins (B) and (C) fig. 78 from the

housing (D) and (E) fig. 78;

If the seat is completely folded down,

remove the parcel shelf as described

and store it horizontally between the

Proceed as follows:

open the rear doors and remove the

parcel shelf (as described previously);

completely lower the rear seat head

restraints;

76

F0T0142

47

move the seat belt to the side,

making sure that it is fully extended and

not twisted;

B

lift backrest retainer lever (A) fig. 79

and fold the backrest forwards to

obtain a flat loading area. When you lift

the lever, you will see a red band.

A

Versions with single rear seat

A

81

F0T0445

80

F0T0416

To further expand the boot, pull tab (A)

fig. 80 located behind the rear backrest

and tip seat and backrest forward.

Qubo versions: To fix the seat, take

the red cords (A) shown in fig. 81 and

fix the ends of the cords in position (A)

and (B) as in fig. 82.

82

F0T0446

48

Versions with split rear seat

(A) anticlockwise to disconnect the

connector.

A

B

83

F0T0289

To further expand the boot, pull the

tabs (A) and (B) fig. 83 located behind

the backrest of the rear seats and tip

seats and backrest forwards.

86

F0T0987

Operate the two brackets (A) fig. 87

under the side of the seat (one on each

side) after having tipped the rear seat

as previously described.

85

F0T0448

A

Rear seat removal (Qubo versions)

The rear seat can be removed to carry

large loads and expand the boot even

further.

84

F0T0447

To fix the seat, take the red cords (A)

shown in fig. 84 and fix the ends of the

cords in position (A) and (B) as in fig. 85

for each of the two portions of the seat.

87

F0T0455

Rear seat removal (Fiorino Combi

versions)

The rear seat can be removed to carry

large loads and expand the boot even

further.

WARNING To remove the rear seat,

first disconnect the SBR sensor

connection on both the right and left

sides, as shown in fig. 86. Turn the ring

49

WARNING To remove the rear seat,

first disconnect the SBR sensor

connection on both the right and left

sides, as shown in fig. 86. Turn the ring

(A) anticlockwise to disconnect the

connector.

WARNING When refitting the rear seat

after removal (for versions/markets

where provided), take care to

reconnect the SBR sensor correctly. If

not, the SBR system will not warn of

any unfastened seat belts on the rear

seats.

Operate the two brackets (A) fig. 88

under the side of the seat (one on each

side) after having tipped the rear seat

as previously described.

Proceed as follows:

90

91

92

F0T0057

F0T0058

F0T0418

check that the seat belt webbing is

correctly inserted in the corresponding

bracket;

take the cushion back to horizontal

position and check that it is secured

correctly;

tip back the backrest and check that

it is secured correctly.

A pictogram fig. 89 is located under

the split seat cushion showing how to

secure the seat back onto the brackets

screwed to the floor.

88

F0T0199

ANCHORING YOUR LOAD

Hooks (various number, according to

version) are fixed to the floor for easy

securing load.

Fiorino Cargo version fig. 90;

Fiorino Combi version fig. 91;

Qubo version fig. 92.

Repositioning the rear seat

89

F0T0302

50

CARGO BOX

(Natural Power versions)

32) Never exceed the maximum allowed

load in the luggage compartment, see

chapter "Technical specifications". Also

make sure that the objects you place in the

luggage compartment have been properly

secured, to avoid them from being thrown

forward consequent to sudden braking

and injuring your passengers.

33) The spring-loaded system is designed

for optimum usage. Accidental knocks

or a strong gust of wind may release the

springs, forcing the doors to close.

34) When closing, shut the right hand door

(2) fig. 73 fully before you close the left

hand door (1) fig. 73. Never shut the two

doors at the same time.

The cargo Box is located in the luggage

compartment and it includes different

sized compartments to store all kinds

of small items. To gain access to the

Cargo Box follow the illustrations in

fig. 93.

94

F0T0353

35) You must not use the folded rear

seat to carry luggage. The load could

be thrown forward into the backrest of

the front seats, seriously injuring the

occupants.

93

F0T0354

Folding the rear seats

95

F0T0352

To fold down the rear seats, in order to

find the (A) fig. 94, you need to open

the cargo box as illustrated in fig. 95.

We recommend you keep the cover

raised in the same position also when

repositioning the seat.

WARNING

30) Do not try to close the tailgate by

pressing on the side shock absorbers (C)

fig. 70. Also be careful not to knock the

side shock absorbers when you load the

boot, to avoid damaging them.

31) If you are travelling in areas with few

filling stations and you want to transport

fuel in a spare tank, comply with the law by

using only an approved, suitably secured

tank. In the event of a collision the fire risk

is increased all the same.

51

Knowing Your Vehicle -> Boot for Your Fiat Fiorino SUV Third Generation (2015-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals