turn the knob (A) to
turn the knob (C) to 4
turn the knob (D) to
bring cursor to (B) to
;
INTERNAL AIR
RECIRCULATION
ACTIVATION
;
;
.
Bring cursor (B) to
.
After demisting/defrosting, operate
the controls as normal to restore the
required comfort conditions.
It is advisable to switch the internal
air recirculation on while standing in
queues or in tunnels to prevent the
introduction of polluted air.
Do not use the function for a long
time, particularly if there are several
passengers on board, to prevent the
windows from steaming up.
Window demisting
In the event of considerable external
moisture and/or rain and/or large
differences in temperature inside and
outside the passenger compartment,
perform the following preventive
window demisting procedure:
51
F0T0048
WARNING Do not apply stickers on
the inside of the rear window over the
heating filaments to avoid damage.
WARNING Internal air recirculation
makes it possible to reach the required
heating or cooling conditions more
quickly depending on the selected
operating mode. Do not use the
internal air recirculation function on
rainy/cold days to avoid the possibility
of the windows misting.
bring cursor to (B) to
turn the knob (A) to
turn the knob (C) to 2;
turn the knob (D) to
;
ADDITIONAL HEATER
(for versions/markets, where provided)
This device warms up the passenger
compartment more quickly when it
is very cold and the engine coolant
temperature is low.
The additional heater comes on
automatically when the engine is
started, if knob (A) is turned to the last
red sector and the fan (knob (C)) is at
least at the first speed level.
;
with the
option of moving to position
if there
is no sign of the windows misting up.
ADJUSTING THE FAN
SPEED
To ventilate the passenger
compartment properly, proceed as
follows:
fully open the central and side air
vents
turn knob (A) to the blue section;
HEATED REAR
WINDOW AND DOOR
MIRRORS DEMISTING /
DEFROSTING
(for versions/markets, where provided)
Press button
fig. 51 to activate the
function. The LED on the button comes
on to indicate activation.
bring cursor to (B) to
turn knob (C) to the required speed.
turn the knob (D) to
;
.
Press
again to disable the function
in advance.
38
English 
