dangerous for oncoming traffic where
you can change the wheel safely. The
ground must be flat and sufficiently
compact;
FUSES
CHANGING A WHEEL
139) 140)
45)
141) 142) 143) 144) 145) 146)
JACK
Please note that:
switch off the engine, pull up the
st
WARNING
handbrake and engage 1 gear or
reverse;
the jack weight is 1.76 kg;
the jack requires no adjustment;
the jack cannot be repaired and in
the event of a fault it must be replaced
by another genuine one;
139) Replacement of a fuse. All
work may be performed only by a Fiat
Dealership or a qualified repair workshop.
The replacement of a fuse by a third party
may cause a serious car fault.
put on the reflective safety jacket
before getting out of the car (if required
by the regulations in force). In any case,
follow the road safety laws in force in
the country where you are driving;
open the boot and lift up the mat (A)
fig. 150;
no tool other than its cranking device
may be fitted on the jack.
140) Installation of electrical
accessories. The car’s electrical circuit
is designed to function with standard or
optional equipment, before installing other
electrical equipment or accessories in the
vehicle contact a Fiat dealership or a
qualified repair workshop.
Jack maintenance
prevent any dirt from depositing on
the "worm screw";
keep the "worm screw" lubricated;
never modify the jack.
Conditions in which not to use the
jack
IMPORTANT
temperature below -40°C
on sandy or muddy ground
on uneven ground
45) The Manufacturer shall not be held
liable for expenses resulting from car
repair or anomalies resulting from the
installation of accessories not provided or
recommended by the Manufacturer and
not installed according to specifications,
in particular when the combined
on steep roads
150
F1D0723
in extreme weather conditions:
thunderstorms, typhoons, hurricanes,
blizzards, storms, etc.
in direct contact with the engine or
for repairs under the car
on boats.
For the VAN version, the tools are
located in the dedicated compartment
under the boot floor mat.
consumption of all additional equipment
connected exceeds 10 mA.
For the 4x4 version, the tools are
located in 4x4 bag located under the
driver seat or in the boot.
CHANGING PROCEDURE
Proceed as follows:
stop the car in a position that is not
129
English 
