GETTING TO KNOW YOUR CAR -> STEERING COLUMN LOCK for Your Fiat Tipo 4 Door Second Generation (2015-2026)

will still be running. The car will indicate  
the absence of the key on board when  
the door is closed.  
NOTE If the device does switch off the  
engine, refer to the “Display” paragraph  
in the “Knowing the instrument panel”  
chapter, where available, and contact  
the Fiat Dealership as soon as possible.  
For more information on the engine  
start-up, see the description in the  
"Starting the engine" paragraph, in the  
"Starting and driving" chapter.  
6
P2000295  
7
P2000305  
The ignition device is fitted with a  
The ignition device has the following  
possible states:  
safety system that requires the ignition  
device to be turned back to STOP if  
the engine does not start, before the  
starting operation can be repeated.  
3) 4)  
STEERING COLUMN  
LOCK  
Activation  
STOP: engine off, steering locked.  
Some electrical devices (e.g. central  
door locking system, alarm, etc.) are  
still available;  
MAR: driving position. All electrical  
devices are available. This state can  
be selected by pressing the ignition  
device button once, without pressing  
the clutch pedal;  
Versions with mechanical key: with the  
device at STOP, remove the key and  
turn the steering wheel until it locks.  
Versions with electronic key  
("Keyless Entry/Go" system)  
To activate the ignition device fig. 7  
the electronic key must be inside the  
passenger compartment.  
WARNING If the ignition key has been  
moved from the MAR to the STOP  
position, the steering lock cannot  
engage until the key is removed from  
the ignition device.  
AVV: engine starting.  
The ignition device activates also if the  
electronic key is inside the boot or on  
the rear shelf.  
NOTE The ignition device does NOT  
activate if the electronic key is inside  
the boot and this is open.  
Versions with electronic key: the  
NOTE With the ignition device at MAR,  
if 30 minutes pass with car stationary  
and the engine stopped, the ignition  
device will automatically move to the  
STOP position.  
steering lock engages when the driver  
door is opened, with the ignition device  
button at STOP and speed 3 km/h.  
Deactivation  
NOTE With the engine running, it is  
possible to go away from the car taking  
the electronic key with you. The engine  
Versions with mechanical key: slightly  
moving the steering wheel, turn the key  
to the MAR position.  
13  
Versions with electronic key: the  
steering lock disengages when the  
ignition device is pressed and the  
electronic key is recognised.  
5) 6) 7) 8)  
the "Starting the engine" paragraph,  
"Starting and driving" chapter.  
the vehicle is parked on a steep slope,  
chock the wheels with wedges or stones.  
When leaving the car, always lock all the  
doors by pressing the dedicated button  
on the handle (see "Passive Entry" in the  
paragraph "Doors").  
IRREGULAR OPERATION  
If, during starting, the key code is not  
correctly recognised, the  
symbol is  
8) For versions equipped with the Keyless  
Entry/Go system, do not leave the  
electronic key inside or near the car or in a  
place accessible to children. Do not leave  
the vehicle with the ignition device in MAR  
position. A child could activate the electric  
window winders, other controls or even  
start the vehicle.  
displayed on the instrument panel (see  
the instructions in the "Warning lights  
and messages" paragraph, "Knowing  
the instrument panel" chapter). This  
condition leads to the engine switching  
off after 2 seconds. In this case, bring  
the ignition device to STOP and then  
to MAR; if it is still blocked, try with  
the other keys provided. If it is still not  
possible to start the engine, contact a  
Fiat Dealership.  
IMPORTANT  
3) If the ignition device has been tampered  
with (e.g. attempted theft), have it checked  
over by a Fiat Dealership before driving  
again.  
4) Always take the key with you when  
you leave your car to prevent someone  
from accidentally operating the controls.  
Remember to engage the parking brake.  
Never leave children unattended in the  
vehicle.  
5) It is absolutely forbidden to carry out  
any after-market operation involving  
steering system or steering column  
modifications (e.g.: installation of  
anti-theft device) that could badly affect  
performance and safety, invalidate  
warranty and also result in non-compliance  
of the car with type approval requirements.  
6) Never extract the mechanical key while  
the car is moving. The steering wheel will  
automatically lock as soon as it is turned.  
This holds true for cars being towed as  
well.  
7) Before leaving the car, ALWAYS engage  
the parking brake, steer the wheels,  
engage the first gear if facing uphill or  
reverse if facing downhill. On versions  
with dual clutch automatic transmission,  
move the gear lever to P (Park) and press  
the ignition device to set it to STOP. If  
FIAT CODE  
The Fiat Code system prevents  
unauthorised use of the car, disabling  
engine starting.  
If the  
symbol is displayed while  
driving, this means that the system is  
running a self-diagnosis (e.g. due to a  
voltage drop). If the display persists,  
contact a Fiat Dealership.  
The system does not need to be  
enabled/activated: operation is  
automatic, regardless of the fact that  
the car's doors are locked or unlocked.  
When the ignition device is set to MAR,  
the Fiat Code system identifies the  
code transmitted by the key. If the  
code is recognised as valid, the Fiat  
Code system enables engine starting.  
When the ignition device is brought  
back to STOP, the Fiat Code system  
deactivates the control unit controlling  
the engine, thus preventing its starting.  
For the correct engine starting  
WARNINGS  
Do not tamper with the Fiat Code  
system.  
Any modifications/alterations could  
cause the protection function to be  
deactivated.  
The Fiat Code system is not compatible  
with certain aftermarket remote starting  
systems. The use of these devices  
could cause problems when starting  
and the deactivation of the protection  
function.  
procedures, see the instructions in  
14