Proceed as follows:
consumption of all additional equipment
connected exceeds 10 mA.
IMPORTANT
stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely. The
ground must be flat and sufficiently
compact;
stop the engine, engage the hazard
warning lights and the parking brake;
engage first gear or reverse;
wear the reflective safety jacket
before getting out of the car (anyway
comply with the laws in force in the
country you are driving in);
144) Before replacing the bulb, wait for the
exhaust ducts to cool down: DANGER OF
SCALDING!
CHANGING A WHEEL
JACK
Please note that:
FUSES
the jack weight is 2.15 kg;
the jack cannot be repaired and in
the event of a fault it must be replaced
by another genuine one;
No tool other than its cranking device
may be fitted on the jack.
145) 146)
56)
IMPORTANT
using the key (4) located in the
tool container, undo the lock ring (1)
fig. 179;
145) Replacement of a fuse. All
work may be performed only by a Fiat
Dealership or a qualified repair workshop.
The replacement of a fuse by a third party
may cause a serious car fault.
Maintenance
Prevent any dirt from depositing on
the "worm screw";
Keep the "worm screw" lubricated;
Never modify the jack.
146) Installation of electrical
accessories. The car’s electrical circuit
is designed to function with standard or
optional equipment, before installing other
electrical equipment or accessories in the
vehicle contact a Fiat dealership or a
qualified repair workshop.
Conditions for non-use
Temperatures below −40°C;
On sandy or muddy ground;
On uneven ground;
On steep roads;
In extreme weather conditions:
thunderstorms, typhoons, hurricanes,
blizzards, storms, etc.;
WARNING
179
P2000059-000-000
In direct contact with the engine or
for repairs under the car;
On boats.
56) The manufacturer shall not be held
liable for expenses resulting from car
repair or anomalies resulting from the
installation of accessories not provided or
recommended by the manufacturer and
not installed according to specifications,
in particular when the combined
take out the toolbox (3) and bring it
next to the wheel to be replaced;
take the spare or space-saver wheel
(2);
for versions with steel rim: remove
the hub cap (1) fig. 180 using the
specific tool (2) fig. 181, located in the
CHANGING PROCEDURE
147) 148) 149) 150) 151) 152)
57) 58)
161
English 
