2009-2016 Ford Ka 2 Door SERVICING AND CARE -> BODYWORK User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

SERVICING AND CARE -> BODYWORK for Your Ford Ka 2 Door Second Generation (2009-2016)

133-146 Ford KA EN:131-148 Ford KA IT 14-10-2010 11:41 Pagina 144  
ADVICE FOR PRESERVING  
THE BODYWORK  
spraying the underbody,  
BODYWORK  
engine compartment, internal wheel  
arches and other parts with highly  
protective wax products;  
PROTECTION FROM  
ATMOSPHERIC AGENTS  
Paint  
spraying of protective plastic  
material in the more exposed  
points: underdoor, inner mudguard  
parts, edges, etc...;  
Paintwork does not only serve  
an aesthetic purpose, but also protects  
the underlying sheet metal.  
The main causes of corrosion are  
the following:  
Touch-up abrasions and scratches  
immediately to prevent the formation  
of rust. Only use genuine spare paint  
products for touch-ups (see “Bodywork  
paint identification plate” in the  
atmospheric pollution;  
use of “open” boxed sections  
to prevent condensation and pockets  
of moisture which could cause  
rust inside.  
salty air and humidity (coastal areas,  
or hot humid climates);  
seasonal environmental conditions.  
“Technical Specifications” chapter).  
The abrasive action of wind-borne  
atmospheric dust and sand, as well  
as mud and gravel raised by other  
cars is also not to be underestimated.  
BODY AND UNDERBODY  
WARRANTY  
Standard maintenance of paintwork  
consists in washing the vehicle;  
its frequency depends on the conditions  
and environment where the vehicle  
is used. For example, in highly polluted  
areas, or if the roads are sprayed with  
salt, it is advisable to wash the car  
more frequently.  
Your car is covered by warranty against  
perforation due to rust of any original  
element of the structure or body.  
On your car, Ford implemented  
the best manufacturing technologies  
to effectively protect the bodywork  
against corrosion.  
For the general terms of this warranty,  
refer to the Warranty Booklet.  
These include:  
painting products and systems which  
give the car particular resistance  
to corrosion and abrasion;  
use of galvanised (or pretreated)  
steel sheets, with high resistance  
to corrosion;  
144  
133-146 Ford KA EN:131-148 Ford KA IT 14-10-2010 11:41 Pagina 145  
To correctly wash the vehicle, proceed  
as follows:  
Do not wash the car after it has been  
left in the sun or with the bonnet hot:  
this may alter the shine of the  
paintwork.  
Glasses  
To clean glasses, use specific window  
cleaner products.  
remove the aerial from the roof  
to prevent damage to it if the car  
is washed in an automatic system;  
Also use clean cloths to avoid  
scratching the glass or damaging  
the transparency.  
Exterior plastic parts must be cleaned  
in the same way as the rest of the car.  
if high pressure jets or cleaners  
are used to wash the vehicle, hold at  
least 40 cm away from the bodywork  
to avoid damage or alteration.  
It should be remembered that  
the build up of water can damage  
the car over a period of time;  
Where possible, do not park under  
trees; the resinous substance that many  
species release give the paint a dull  
appearance and increase the possibility  
of triggering rusting processes.  
IMPORTANT Wipe the rear window  
inside gently with a cloth in the  
direction of the filaments to avoid  
damaging the heating device.  
IMPORTANT Bird droppings must be  
washed off immediately and thoroughly  
as the acid they contain is particularly  
aggressive.  
wash the body using a low pressure  
jet of water;  
wipe a sponge with a slightly  
soapy solution over the bodywork,  
frequently rinsing the sponge;  
rinse well with water and dry with  
a jet of air or a chamois leather.  
Detergents cause water  
pollution. The vehicle should  
be washed in areas equipped  
for collecting and purifying  
Dry the less visible parts particularly  
carefully, such as the door frames,  
bonnet and the headlight frames,  
where water may stagnate more easily.  
The car should not be taken to a closed  
area immediately, but left in the open  
so that residual water can evaporate.  
the liquid used in the washing process.  
145  

Related Topics

Popular Owner Manuals