133-146 Ford KA EN:131-148 Ford KA IT 14-10-2010 11:41 Pagina 137
BRAKE FLUID fig. 1-2
WARNING
The symbol π, on the
synthetic brake fluid, which is
different from a mineral fluid.
Use of a mineral type fluid will
damage the special rubber seals of
the braking system beyond repair.
Prevent brake fluid which
is highly corrosive from
coming into contact with
Undo the cap E: and check that the
liquid contained in the reservoir is
at the maximum level.
container, indicates a
painted parts. Should this
occur, immediately wash with water.
Fluid level in the reservoir must not
exceed the MAX mark.
Use the brake fluid shown in
the “Fluids and lubricants” table
(see section “Technical Specifications”)
to top up.
WARNING
Brake fluid is poisonous
and highly corrosive.
In the event of accidental contact,
immediately wash the affected
parts with water and neutral soap.
Then rinse thoroughly. In case
of swallowing immediately call
a doctor.
Note Carefully clean the cap of
reservoir E and the surrounding surface.
Take great care to ensure that
impurities do not enter the reservoir
when the cap is opened.
For topping-up, always use a funnel
with integrated filter with mesh equal
to or lower than 0.12 mm.
IMPORTANT Brake fluid is hygroscopic
(i.e. it absorbs moisture). For this
reason, if the car is mainly used in areas
with a high degree of atmospheric
humidity, the fluid should be replaced at
more frequent intervals than specified in
the “Service schedule”.
137
English 
