2009-2016 Ford Ka 2 Door SERVICING AND CARE -> WINDSCREEN/REAR WINDOW WIPERS User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

SERVICING AND CARE -> WINDSCREEN/REAR WINDOW WIPERS for Your Ford Ka 2 Door Second Generation (2009-2016)

133-146 Ford KA EN:131-148 Ford KA IT 14-10-2010 11:41 Pagina 142  
WINDSCREEN/REAR  
WARNING  
Driving with worn wiper  
blades is a serious hazard,  
because visibility is reduced in bad  
weather.  
WINDOW WIPERS  
BLADES  
Clean the rubber part regularly using  
special products.  
Replace the blades if the rubber edge  
is deformed or worn. In all cases, it is  
advisable to replace them approximately  
once a year.  
KA00199m  
fig. 6  
A few simple precautions can reduce  
the possibility of damage to the blades:  
Changing the windscreen  
wiper blades fig. 6  
make sure that the rubber part is not  
stuck to the windscreen at sub-zero  
temperatures. Use a de-icing product  
to release it if required;  
remove any snow from the glass:  
in addition to protecting the blades,  
this prevents effort on the motor  
and overheating;  
Proceed as follows:  
lift the arm B of the wiper and  
position the blade C so that it forms  
an angle of 90° with the arm itself;  
press the button A and extract from  
the arm B the brush C;  
insert the new blade making sure  
it is locked.  
do not operate the windscreen and  
the rear screen wipers on dry glass.  
142  
133-146 Ford KA EN:131-148 Ford KA IT 14-10-2010 11:41 Pagina 143  
KA00079m  
KA00080m  
KA00200m  
fig. 8  
fig. 9  
fig. 7  
Changing the rear  
window wiper blade fig. 7  
SPRAY NOZZLES  
Windscreen washer fig. 8  
Rear window washer fig. 9  
The rear window washer jets are fixed.  
The nozzle holder is on the rear window.  
Proceed as follows:  
If the jet of fluid is inadequate, firstly  
check that there is fluid in the reservoir:  
see “Checking fluid levels” in this  
chapter).  
raise the cover A and remove  
the arm from the car, slackening the  
nut B that fastens it to the pivot pin;  
position the new arm correctly  
and tighten the nut;  
Then check that the nozzle holes  
are not clogged, if necessary clean  
them using a needle.  
lower the cover.  
The windscreen jets are directed  
by adjusting the nozzle angle.  
The jets must be directed at about 1/3  
of the height from the window  
upper edge.  
WARNING In versions with a sun roof,  
make sure that the sun roof is closed  
before operating the front jets.  
143  

Related Topics

Popular Owner Manuals