Features of your vehicle -> Wipers and washers for Your Hyundai I10 4 Door First Generation (2007-2012)

Features of your vehicle  
WIPERS AND WASHERS  
Type A  
Listed below are the examples of proper  
switch settings. For loading conditions  
other than those listed below, adjust the  
switch position so that the beam level  
may be the nearest as the condition  
obtained according to the list.  
Operates as follows when the ignition  
switch is turned ON.  
: For a single wiping cycle, push the  
lever upward and release it with  
the lever in the OFF position. The  
wipers will operate continuously if  
the lever is pushed upward and  
held.  
Loading condition  
Switch position  
0 : Wiper is not in operation  
Driver only  
0
0
1
OPA041069  
--- : Wiper operates intermittently at  
the same wiping intervals. Use this  
mode in a light rain or mist.  
(if equipped)  
Driver + Front passenger  
Driver + Full passengers  
Full passengers (including  
driver) + Maximum per-  
missible loading  
Type B  
1 : Normal wiper speed  
2 : Fast wiper speed  
2
3
NOTICE  
Driver + Maximum per-  
missible loading  
If there is heavy accumulation of snow  
or ice on the windshield, defrost the  
windshield for about 10 minutes, or  
until the snow and/or ice is removed  
before using the windshield wipers to  
ensure proper operation.  
OPA041400  
Type C  
OPA041403  
D200100APA  
Windshield wipers  
4 52  
Features of your vehicle  
Type A  
In the OFF position, pull the lever gently  
toward you to spray washer fluid on the  
windshield and to run the wipers 1-3  
cycles.  
CAUTION  
To prevent possible damage to the  
washer pump, do not operate the  
washer when the fluid reservoir is  
empty.  
Use this function when the windshield is  
dirty.  
The spray and wiper operation will con-  
tinue until you release the lever.  
If the washer does not work, check the  
washer fluid level. If the fluid level is not  
sufficient, you will need to add appropri-  
ate non-abrasive windshield washer fluid  
to the washer reservoir.  
WARNING  
OPA041070  
OPA041401  
OPA041404  
Do not use the washer in freezing  
temperatures without first warming  
the windshield with the defrosters;  
the washer solution could freeze on  
contact with the windshield and  
obscure your vision.  
Type B  
The reservoir filler neck is located in the  
front of the engine compartment on the  
passenger side.  
CAUTION  
• To prevent possible damage to  
the wipers or windshield, do not  
operate the wipers when the  
windshield is dry.  
Type C  
• To prevent damage to the wiper  
blades, do not use gasoline,  
kerosene, paint thinner, or other  
solvents on or near them.  
• To prevent damage to the wiper  
arms and other components, do  
not attempt to move the wipers  
manually.  
D200200AUN  
Windshield washers  
4 53  
Features of your vehicle  
Type A  
0 - Wiper is not in operation  
- Normal wiper operation  
- Spraying washer fluid and wiping  
OPA041071  
Type B  
OPA041402  
D200300APA  
Rear window wiper and washer  
switch (if equipped)  
The rear window wiper and washer  
switch is located at the end of the wiper  
and washer switch lever. Turn the switch  
to desired position to operate the rear  
wiper and washer.  
4 54