Maintenance -> Wiper blades for Your Hyundai I10 4 Door First Generation (2007-2012)

Maintenance  
WIPER BLADES  
3.Replace the climate control air filter.  
(for Europe)  
Contamination of either the windshield or  
the wiper blades with foreign matter can  
reduce the effectiveness of the wind-  
shield wipers. Common sources of con-  
tamination are insects, tree sap, and hot  
wax treatments used by some commer-  
cial car washes. If the blades are not wip-  
ing properly, clean both the window and  
the blades with a good cleaner or mild  
detergent, and rinse thoroughly with  
clean water.  
• Inspect and clean the climate control  
filter by water.  
4. Reassemble in the reverse order of  
disassembly.  
NOTICE  
When replacing (For Europe) or  
inspecting (Exept Europe) the climate  
control air filter install it properly.  
Otherwise, the system may produce  
noise and the effectiveness of the filter  
may be reduced.  
1JBA5122  
CAUTION  
G180100AUN  
To prevent damage to the wiper  
blades, do not use gasoline,  
kerosene, paint thinner, or other  
solvents on or near them.  
Blade inspection  
NOTICE  
Commercial hot waxes applied by auto-  
matic car washes have been known to  
make the windshield difficult to clean.  
7 36  
Maintenance  
G180200AUN  
Blade replacement  
When the wipers no longer clean ade-  
quately, the blades may be worn or  
cracked, and require replacement.  
CAUTION  
To prevent damage to the wiper  
arms or other components, do not  
attempt to move the wipers manual-  
ly.  
1JBA7037  
1LDA5023  
G180201AUN  
CAUTION  
Front windshield wiper blade  
The use of a non-specified wiper  
blade could result in wiper malfunc-  
tion and failure.  
1. Raise the wiper arm and turn the wiper  
blade assembly to expose the plastic  
locking clip.  
CAUTION  
Do not allow the wiper arm to fall  
against the windshield, since it may  
chip or crack the windshield.  
1JBA7038  
2. Compress the clip and slide the blade  
assembly downward.  
3. Lift it off the arm.  
4. Install the blade assembly in the  
reverse order of removal.  
7 37  
Maintenance  
OPA077017  
OPA077018  
G180202AEN  
2. Install the new blade assembly by  
inserting the center part into the slot in  
the wiper arm until it clicks into place.  
Rear window wiper blade  
1. Raise the wiper arm and pull out the  
wiper blade assembly.  
3. Make sure the blade assembly is  
installed firmly by trying to pull it slight-  
ly.  
To prevent damage to the wiper arms or  
other components, have an authorized  
HYUNDAI dealer replace the wiper  
blade.  
7 38