Maintenance -> WIPER BLADES for Your Hyundai I10 4 Door Second Generation (2013-2019)

Maintenance  
WIPER BLADES  
Contamination of either the windshield or  
the wiper blades with foreign matter can  
reduce the effectiveness of the wind-  
shield wipers. Common sources of con-  
tamination are insects, tree sap, and hot  
wax treatments used by some commer-  
cial car washes. If the blades are not wip-  
ing properly, clean both the window and  
the blades with a good cleaner or mild  
detergent, and rinse thoroughly with  
clean water.  
Blade replacement  
When the wipers no longer clean ade-  
quately, the blades may be worn or  
cracked, and require replacement.  
CAUTION  
To prevent damage to the wiper  
arms or other components, do not  
attempt to move the wipers manual-  
ly.  
1JBA5122  
CAUTION  
CAUTION  
The use of a non-specified wiper  
blade could result in wiper malfunc-  
tion and failure.  
Blade inspection  
To prevent damage to the wiper  
blades, do not use gasoline,  
kerosene, paint thinner, or other  
solvents on or near them.  
NOTICE  
Commercial hot waxes applied by auto-  
matic car washes have been known to  
make the windshield difficult to clean.  
7 34  
Maintenance  
1JBA7037  
1LDA5023  
OHM078059  
Type B  
1.Raise the wiper arm.  
Front windshield wiper blade  
Type A  
1.Raise the wiper arm and rotate the  
wiper blade assembly to expose the  
plastic locking clip.  
CAUTION  
Do not allow the wiper arm to fall  
against the windshield, since it may  
chip or crack the windshield.  
CAUTION  
Do not allow the wiper arm to fall  
against the windshield, since it may  
chip or crack the windshield.  
1JBA7038  
2.Compress the clip (1) and slide the  
blade assembly downward (2).  
3.Lift it off the arm.  
4.Install a blade assembly in the reverse  
order of removal.  
5.Return the wiper arm on the wind-  
shield.  
7 35  
Maintenance  
OHM078060  
OHM078061  
OPA077017  
2.Lift up the wiper blade clip (1). Then  
pull down the blade assembly (2) and  
remove it.  
3.Install a new blade assembly in the  
reverse order of removal.  
4.Return the wiper arm on the wind-  
shield.  
Rear window wiper blade  
(if equipped)  
1.Raise the wiper arm and pull out the  
wiper blade assembly.  
2.Slightly rotate the wiper blade assem-  
bly (1) and pull it out.  
7 36  
Maintenance  
OPA077018  
3.Install a new blade assembly by insert-  
ing the center part into the slot on the  
wiper arm until it clicks into place.  
4.Make sure the blade assembly is  
installed firmly by trying to pull it slight-  
ly.  
To prevent damage to the wiper arms or  
other components, we recommend that  
the wiper blade be replaced by an  
authorized HYUNDAI dealer.  
7 37