Emergency situations
OBC3N080005
ODN8079020
5. Insert the sealant bottle into the
housing (5) of the compressor so that
the bottle is upright.
7. Connect between compressor and the
vehicle power outlet using the cable
and connectors (4).
6. Ensure that the compressor is
switched off, position 0.
8.With the engine start/stop button
position on or ignition switch position
on, switch on the compressor and let
it run for approximately 5~7 minutes to
fill the sealant up to proper pressure.
(refer to immediately chapter 2).
The inflation pressure of the tyre
immediately filling is unimportant and
will be checked/corrected later.
Be careful not to overinflate the tyre
and stay away from the tyre whilst
filling it.
NOTICE
OBC3080011
- Tyre pressure
NOTICE
Do not attempt to drive your vehicle
if the tyre pressure is below 29
Securely install the sealant filling hose
to the valve. If not, sealant may flow
backward, possibly clogging the filling
hose.
PSI(200kpa). This could result in an
accident due to sudden tyre failure.
9.Switch off the compressor.
10. Detach the hoses from the sealant
bottle connector and from the tyre
valve.
Return the Tyre Mobility Kit to its storage
location in the vehicle.
8-30
English 
