Get Maintenance -> Light bulbs Guide for Hyundai I30 4 Door Third Generation (2016-2026)

Maintenance

LIGHT BULBS

G220000AFD-EA

✽

NOTICE

CAUTION

After heavy, driving rain or washing,

headlight and taillight lenses could

appear frosty. This condition is caused by

the temperature difference between the

lamp inside and outside. This is similar

to the condensation on your windows

inside your vehicle during the rain and

doesn’t indicate a problem with your

vehicle. If the water leaks into the lamp

bulb circuitry, have the vehicle checked

by an authorised HYUNDAI dealer.

If you don’t have necessary tools,

the correct bulbs and the expertise,

consult an authorised HYUNDAI

dealer. In many cases, it is difficult

to replace vehicle light bulbs

because other parts of the vehicle

must be removed before you can

get to the bulb. This is especially

true if you have to remove the head-

light assembly to get to the bulb(s).

Removing/installing the headlight

assembly can result in damage to

the vehicle.

WARNING - Working on

the lights

Prior to working on the light, firmly

apply the hand brake, ensure that

the ignition switch is turned to the

“LOCK” position and turn off the

lights to avoid sudden movement

of the vehicle and burning your fin-

gers or receiving an electric shock.

Use only the bulbs of the specified

wattage.

All bulbs are available from your

HYUNDAI dealers Parts Department.

CAUTION

Be sure to replace the burned-out

bulb with one of the same wattage

rating. Otherwise, it may cause

damage to the fuse or electric

wiring system.

7 62

Maintenance

(Continued)

• If a bulb becomes damaged or

cracked, replace it immediately

and carefully dispose of it.

• Wear eye protection when chang-

ing a bulb. Allow the bulb to cool

down before handling it.

OHD076046

OFD067021

G220100AUN

G220101AFD-EA

Headlight bulb

Headlight, position light, turn sig-

nal light, front fog light bulb

replacement

(1) Headlight (High)

(2) Headlight (Low)

WARNING - Halogen bulbs

• Halogen bulbs contain pressur-

ized gas that will produce flying

pieces of glass if broken.

(3) Position light

• Always handle them carefully,

and avoid scratches and abra-

sions. If the bulbs are lit, avoid

contact with liquids. Never touch

the glass with bare hands.

Residual oil may cause the bulb

to overheat and burst when lit. A

bulb should be operated only

when installed in a headlight.

(4) Front turn signal light

(5) Front fog light (if equipped)

(Continued)

7 63

Maintenance

8. Connect the headlight bulb socket-

connector.

9. Install the headlight bulb cover by turn-

ing it clockwise.

10. Install the headlight assembly. (for

low beam bulb)

✽

NOTICE

If the headlight aiming adjustment is

necessary after the headlight assembly is

reinstalled, consult an authorized

HYUNDAI dealer.

OHD076035

OFD077023

F220200AUN

1. Open the bonnet.

G220102AFD

Side repeater light bulb replace-

ment (if equipped)

1. Remove the light assembly from the

vehicle by prying the lens and pulling

the assembly out.

2. Disconnect the bulb electrical connec-

tor.

3. Separate the socket and the lens parts

by turning the socket counterclockwise

until the tabs on the socket align with

the slots on the lens part.

2. Remove the headlight assembly by

loosening the headlight installation

bolts(3EA). (for replacement of low

beam bulb)

3. Remove the headlight bulb cover by

turning it counterclockwise.

4. Disconnect the headlight bulb socket-

connector.

5. Unsnap the headlight bulb retaining

wire by depressing the end and push-

ing it upward.

Turn signal light/position light, fog

light bulb (if equipped)

Turn signal light/position light

1. Remove the headlight assembly by

loosening the headlight installation

bolts(3EA).

2. Replace the malfunctioned light bulb.

3. Install the headlight assembly.

Fog light bulb

1. Remove the fog light under cover by

loosening the screw(2EA).

6. Remove the bulb from the headlight

assembly.

2. Replace the malfunctioned light bulb.

3. Install the fog light under cover.

7. Install a new headlight bulb and snap

the headlight bulb retaining wire into

position by aligning the wire with the

groove on the bulb.

7 64

Maintenance

5 Door

Wagon

5 Door

4. Remove the bulb by pulling it straight

out.

5. Insert a new bulb in the socket.

6. Reassemble the socket and the lens

part.

7. Connect the bulb electrical connector.

8. Reinstall the light assembly to the

body of the vehicle.

OFD067025

Wagon

OFD067024/OFD067040

G220300BFD

Rear combination light bulb

replacement

5 Door

(1) Stop and tail light or tail light

(2) Rear turn signal light

(3) Back-up light

(4) Rear fog light (if equipped) or stop

light

OFD067041

1. Open the tailgate.

2. Loosen the light assembly retaining

screws with a cross-tip screwdriver.

Wagon

(1) Tail light

3. Remove the rear combination light

assembly from the body of the vehicle.

(2) Rear turn signal light

(3) Back-up light

(4) Stop light

7 65

Maintenance

OFD067027

OED076055

OFD067030

G220400AFD-EA

G220400AFD

4. Remove the socket from the assembly

by turning the socket counterclockwise

until the tabs on the socket align with

the slots on the assembly.

5. Remove the bulb from the socket by

pressing it in and rotating it counter-

clockwise until the tabs on the bulb

align with the slots in the socket. Pull

the bulb out of the socket.

High mounted stop light replace-

ment

If the light is not operating, have the vehi-

cle checked by an authorised HYUNDAI

dealer.

License plate light bulb replace-

ment

1. Remove the lens by pressing the tabs.

2. Remove the socket from the lens.

3. Remove the bulb by pulling it straight

out.

4. Install a new bulb in the socket and

install the socket to the lens.

6. Insert a new bulb by inserting it into

the socket and rotating it until it locks

into place.

5. Reinstall the lens securely.

7. Install the socket in the assembly by

aligning the tabs on the socket with the

slots in the assembly. Push the socket

into the assembly and turn the socket

clockwise.

8. Reinstall the light assembly to the

body of the vehicle.

7 66

Maintenance

G220600AUN

Front map lamp

Sunvisor lamp

Interior light bulb replacement

1. Using a flat-blade screwdriver, gently

pry the lens from the interior light

housing.

2. Remove the bulb by pulling it straight

out.

WARNING

OFD077031

OFD077032

OFD077035

OFD077033R

Dome lamp

Glove box lamp (if equipped)

Prior to working on the Interior

Lights, ensure that the “OFF” but-

ton is depressed to avoid burning

your fingers or receiving an electric

shock.

3. Install a new bulb in the socket.

4. Align the lens tabs with the interior

light housing notches and snap the

lens into place.

OFD077034R

Luggage room lamp (if equipped)

CAUTION

Use care not to dirty or damage

lens, lens tab, and plastic housings.

7 67

Maintenance -> Light bulbs for Your Hyundai I30 4 Door Third Generation (2016-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals