JD eng 4a.QXP 3/4/2015 4:31 PM Page 151
Features of your vehicle
CLEAN AIR (IF EQUIPPED)
This indicator illuminates
when the auto defogging
system senses the moisture
of inside the windshield and
operates.
✽
NOTICE
If the A/C off is manually selected while
the auto defogging system is on, the auto
defogging indicator will blink 3 times to
give notice that the A/C off can not be
selected.
If more moisture is in the vehicle, higher
steps operate as follow.
CAUTION
Do not remove the sensor cover
located on the upper end of the
driver side windshield glass.
Damage to the system parts could
occur and may not be covered by
your vehicle warranty.
Step 1 : Operating the air conditioning
Step 2 : Outside air position
Step 3 : Blowing air flow toward the wind-
shield
OJD042129
When the ignition switch is in the ON
position, the clean air function turns on
automatically.
Step 4 : Increasing air flow toward the
windshield
Also, the clean air function turns off auto-
matically, when the ignition switch turns
to the OFF position.
If your vehicle is equipped with the auto
defogging system, it is automatically acti-
vated when the conditions are met.
However, if you would like to cancel the
auto defogging system, press the front
defroster button 4 times within 2 seconds
while pressing the AUTO button. The
indicator will blink 3 times to notify you
that the system is cancelled. To use the
auto defogging system again, follow the
procedures mentioned above.
If the battery has been disconnected or
discharged, it resets to the auto defog-
ging status.
4 151
English 
