Get Features of your vehicle -> LCD display information Guide for Kia Ceed SUV Second Generation (2013-2018)

JD eng 4a.QXP 3/4/2015 4:25 PM Page 73

Features of your vehicle

■ Normal vision

■ Supervision

OJD042078/OJD042215

OJD042240/OJD042188

OJD042079/OJD042214

Illumination intensity

Turn on "FUSE SWITCH" (mode switch)

LCD display information

Sunroof open

The illumination intensity of the instru-

ment panel is shown when adjusting it

with the illumination control switch.

The notice appears to inform the driver to

turn on the fuse switch in the instrument

panel under the steering wheel.

If driver removes the ignition key (Smart

key : turns off the engine) and opens the

driver-side door when the sunroof is not

fully closed, warning message will appear

on the LCD display. Also, the warning

chime sounds for approximately 7 sec-

onds.

For more details, refer to “Instrument

panel illumination” in chapter 4.

For more details, refer to “Fuses” in chap-

ter 7.

4 73

JD eng 4a.QXP 3/4/2015 4:25 PM Page 74

Features of your vehicle

■ Normal vision

■ Supervision

OJD042163/OJD042196

OJD042164/OJD042211

OJD042073/OJD042205

Parking assist warning (if equipped)

Displays the area an obstacle is detected

while moving forward or rearward.

Align steering wheel (if equipped)

For vehicle’s equipped with smart

key system

Key not in vehicle

If you start the engine when the steering

wheel is turned 90 degrees to the left (or

right) after a couple of seconds, “Align

steering wheel” illuminates on the LCD

display for 5 seconds.

For more details, refer to “Parking assist

system” in chapter 4.

If the smart key is not in the vehicle and

if any door is opened or closed with the

engine start/stop button in the ACC, ON,

or START position, the warning illumi-

nates on the LCD display. Also, the chime

sounds for 5 seconds when the smart

key is not in the vehicle and the door is

closed.

Turn the steering wheel to the right (or left)

and make it turned to the left (or right) less

than 30 degrees.

Always have the smart key with you.

4 74

JD eng 4a.QXP 3/4/2015 4:26 PM Page 75

Features of your vehicle

■ Normal vision

■ Supervision

OJD042072/OJD042204

OJD042075/OJD042207

OJD042066/OJD042198

Key not detected

Press start button with smart key

Low key battery

If the smart key is not in the vehicle or is

not detected and you press the engine

start/stop button, the warning illuminates

on the LCD display for 10 seconds. Also,

the immobilizer indicator blinks for 10

seconds.

If you press the engine start/stop button

while the warning “Key not detected” illu-

minates the warning “Press the start but-

ton with smart key” illuminates for 10 sec-

onds on the LCD display. Also, the immo-

bilizer indicator blinks for 10 seconds.

If the engine start/stop button changes to

the OFF position when the smart key in

the vehicle discharges, the warning illu-

minates on the LCD display for about 10

seconds. Also, the warning chime

sounds once.

Replace the battery with a new one.

4 75

JD eng 4a.QXP 3/4/2015 4:26 PM Page 76

Features of your vehicle

■ Normal vision

■ Supervision

OJD042070/OJD042202

OJD042071/OJD042203

OJD042065/OJD042197

Press brake pedal to start engine

(for automatic transaxle)

Press clutch pedal to start engine

(for manual transaxle)

Shift to "P" position

(for automatic transaxle)

If the engine start/stop button changes to

the ACC position twice by pressing the

button repeatedly without depressing the

brake pedal, the warning illuminates on

the LCD display for about 10 seconds to

indicate that you should depress the

brake pedal to start the engine.

If the engine start/stop button turns to the

ACC position twice by pressing the but-

ton repeatedly without depressing the

clutch pedal, the warning illuminates on

the LCD display for about 10 seconds to

indicate that you should depress the

clutch pedal to start the engine.

If you try to turn off the engine without the

shift lever in the P (Park) position, the

engine start/stop button will turn to the

ACC position. If the button is pressed

once more it will turn to the ON position.

The warning illuminates on the LCD dis-

play for about 10 seconds to indicate that

you should press the engine start/stop

button with the shift lever in the P (Park)

position to turn off the engine.

Also, the warning chime sounds for about

10 seconds. (if equipped)

4 76

JD eng 4a.QXP 3/4/2015 4:26 PM Page 77

Features of your vehicle

■ Normal vision

■ Supervision

OJD042074/OJD042206

OJD042077/OJD042209

OJD042067/OJD042199

Press start button again

Shift to "P" or "N" to start engine

Press start button while turn steering

(if equipped)

If you can not operate the engine

start/stop button when there is a problem

with the engine start/stop button system,

the warning illuminates for 10 seconds

and the chime sounds continuously to

indicate that you could start the engine

by pressing the engine start/stop button

once more.

If you try to start the engine with the shift

lever not in the P(Park) or N(Neutral)

position, the warning illuminates for

about 10 seconds on the LCD display.

If the steering wheel does not unlock nor-

mally when the engine start/stop button

is pressed, the warning illuminates for 10

seconds on the LCD display. Also, the

warning chime sounds once and the

engine start/stop button light blinks for 10

seconds.

You can also start the engine with the

shift lever in the N(Neutral) position, but

for your safety start the engine with the

shift lever in the P(Park) position.

The chime will stop if the engine

start/stop button system works normally

or the theft alarm system is armed.

When you are warned, press the engine

start/stop button while turning the steer-

ing wheel right and left.

If the warning illuminates each time you

press the engine start/stop button, we

recommend that the system be checked

by an authorized Kia dealer.

4 77

JD eng 4a.QXP 3/4/2015 4:26 PM Page 78

Features of your vehicle

■ Normal vision

■ Supervision

OJD042069/OJD042201

OJD042076/OJD042208

OJD043509

Check steering wheel lock system

(if equipped)

Check "BRAKE SWITCH" fuse

Torque reduced due to overheating (for

T-GDI engine)

When the engine coolant temperature

exceeds 115°C, this message will be dis-

played and the torque will be reduced to

protect the engine.

When the brake switch fuse is discon-

nected, the warning illuminates for 10

seconds on the LCD display.

If the steering wheel does not lock nor-

mally when the engine start/stop button

changes to the OFF position, the warning

illuminates for 10 seconds on the LCD

display. Also, the warning chime sounds

for 3 seconds and the engine start/stop

button light blinks for 10 seconds.

Replace the fuse with a new one. If that

is not possible you can start the engine

by pressing the engine start/stop button

for 10 seconds in ACC.

4 78

Features of your vehicle -> LCD display information for Your Kia Ceed SUV Second Generation (2013-2018)

Related Topics

Popular Owner Manuals

Latest Owner Manuals