Get Safety features of your vehicle -> Lap/shoulder belt Guide for Kia Ceed SUV Second Generation (2013-2018)

JD eng 3.QXP 3/4/2015 2:40 PM Page 23

Safety features of your vehicle

■ Front seat

And then, the rear corresponding seat

belt warning light will illuminate for

approximately 35 seconds, if any of fol-

lowing occurs;

To raise the height adjuster, pull it up (1).

To lower it, push it down (3) while press-

ing the height adjuster button (2).

Release the button to lock the anchor

into position. Try sliding the height

adjuster to make sure that it has locked

into position.

- You start the engine when the rear belt

is not fastened.

- You drive over 9km/h when the rear belt

is not fastened.

- The rear belt is disconnected when

driving under 20km/h.

WARNING

• Verify the shoulder belt anchor is

locked into position at the appro-

priate height. Never position the

shoulder belt across your neck or

face. Improperly positioned seat

belts can cause serious injuries

in an accident.

If the rear seat belt is fastened, the warn-

ing light will turn off immediately.

OLM039026

Lap/shoulder belt

Height adjustment (5 Door and Wagon)

You can adjust the height of the shoulder

belt anchor to one of 4 positions for max-

imum comfort and safety.

If the rear seat belt is disconnected when

you drive over the 20km/h, the corre-

sponding seat belt warning light will blink

and warning chime will sound for 35 sec-

onds.

• Failure to replace seat belts after

an accident could leave you with

damaged seat belts that will not

provide protection in the event of

another collision leading to per-

sonal injury or death. Replace

your seat belts after being in an

accident as soon as possible.

The height of the adjusting seat belt

should not be too close to your neck.You

will not be getting the most effective pro-

tection. The shoulder portion should be

adjusted so that it lies across your chest

and midway over your shoulder near the

door and not your neck.

But, if the rear passenger's lap/shoulder

belt is/are connected and disconnected

twice within 9 seconds after the belt is

fastened, the corresponding seat belt

warning light will not operate.

To adjust the height of the seat belt

anchor, lower or raise the height adjuster

into an appropriate position.

3 23

JD eng 3.QXP 3/4/2015 2:40 PM Page 24

Safety features of your vehicle

The seat belt automatically adjusts to the

proper length only after the lap belt por-

tion is adjusted manually so that it fits

snugly around your hips. If you lean for-

ward in a slow, easy motion, the belt will

extend and let you move around. If there

is a sudden stop or impact, however, the

belt will lock into position. It will also lock

if you try to lean forward too quickly.

B180A01NF

CAUTION

■ Rear center seat belt (if equipped)

When using the rear center seat

belt, the buckle with the “CENTER”

mark must be used.

B200A01NF

WARNING

You should place the lap belt por-

tion as low as possible and snugly

across your hips, not on your waist.

If the lap belt is located too high on

your waist, it may increase the

chance of injury in the event of a

collision. Both arms should not be

under or over the belt. Rather, one

should be over and the other under,

as shown in the illustration.

✽

NOTICE

If you are not able to pull out the seat

belt from the retractor, firmly pull the

belt out and release it. Then you will be

able to pull the belt out smoothly.

OJD032026

To fasten your seat belt:

To fasten your seat belt, pull it out of the

retractor and insert the metal tab (1) into

the buckle (2). There will be an audible

"click" when the tab locks into the buckle.

Never wear the seat belt under the

arm near the door.

3 24

Safety features of your vehicle -> Lap/shoulder belt for Your Kia Ceed SUV Second Generation (2013-2018)

Related Topics

Popular Owner Manuals

Latest Owner Manuals